Replacement Wheel Studs for Wheels on 2004 Timberlodge by Adventure Manufacturing
Updated 03/15/2016 | Published 03/12/2016 >
Products Featured in This Question
Question:
I have a 2004 Timberlodge by Adventure Manufacturing. I have broken all but 1 wheel stud, but was able to get it out and get the measurements. I have attached a dimensional diagram with my numbers in the spots needed. Please suggest the correct wheel stud thanks!
asked by: Vic A
0
Expert Reply:
All 1/2-inch diameter drive-in wheel studs are shown on the linked page. The one nearest to your required dimensions (thank you for your included photo) is Kodiak # K12WB2. Overall length is slightly greater but most specs match up closely.
expert reply by:
Adam R
0
Product Page this Question was Asked From
Replacement Trailer Hub Wheel Stud, Drive-In, 1/2" x 1-13/16" (Qty 4)
- Accessories and Parts
- Boat Trailer Wheels
- Trailer Hubs and Drums
- Trailer Tires and Wheels
- Wheel Studs
- 1/2 Inch Diameter
- Drive-In Stud
- 1-13/16 Inch Long
- Redline
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Replacement Wheel Stud that is .545 Diameter and 1/2 - 20
- Q&A: Replacement Bronze Bushings for MoRryde CRE3000 Suspension System
- Q&A: Correct Replacement Wheel Mounting Bolts for a Dexter Hub and Drum Assembly for 3.5K Axles
- Q&A: Torque Specification for Lugs Nuts on 5/8-Inch Stud on Dexter Hub
- Q&A: Where Can I Find a Local Installer to Complete My Installation?
- Article: Which Hitches are Made in the USA
- Article: How to Tell the Weight Rating of a Trailer Axle
- Q&A: Can a Wheel That Uses 1/2 Inch Wheel Studs Be Used on a Trailer that Uses 7/16 Inch Studs
- Q&A: Looking For 1/2" x 20 Wheel Studs With .500" Knurl Diameter
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: Trailer Lighting Requirements
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Most Popular Wheel Bearings


