Shorter Wheel Stud Recommendation for a Trailer Hub 8-247-50UC3
Updated 02/29/2016 | Published 02/27/2016
Products Featured in This Question
Question:
The wheel studs are too long for my wheels. I wont be able to use a standard lug wrench to remove. They need to be about 1/2 inch shorter. what wheel stud part number would work for this drum?
asked by: Jim C
0
Expert Reply:
The wheel studs of the hub part # 8-247-50UC3 are 1/2 inch diameter x 2-1/4 inches long. For studs that are around 1/2 inch shorter than that you would want the # K12WB169 which is 1/2 inch diameter and 1.70 inches long.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Dexter Trailer Hub and Drum Assembly for 3,500-lb Axles - 5 on 4-1/2 - Galvanized
- Trailer Hubs and Drums
- Hub with Drum
- Standard
- L68149 / L44649
- Marine Grade
- For 3500 lbs Axles
- 1/2 Inch Stud
- 5 on 4-1/2 Inch
- 13 Inch Wheel
- 14 Inch Wheel
- 14-1/2 Inch Wheel
- 15 Inch Wheel
- Dexter
more information >
Continue Researching
- Q&A: Will DeeMax Replacement Grease Cap Fit in Place of Dexter Vortex 21-261
- Q&A: Replacement Dexter 8-247 Wheel Hub
- Article: Trailer Wiring Diagrams
- Q&A: Looking for Replacement Wheel Stud for Agricultural Trailer Hub Assembly for 7K Axles TRU55FR
- Q&A: How to Determine Replacement Trailer Wheel Bearing Sizes
- Q&A: Where Are Kenda Tires Manufactured?
- Q&A: What are the Dimensions of Trailer Jack Support Plate # BD003135
- Q&A: Why Were The Kodiak 204 Calipers and Pads Discontinued?
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: Slipper Spring Trailer Suspension System Review
- Article: Trailer Tire Sizing
- Article: Parts Required to Add Electric Over Hydraulic Drum Brakes to a Trailer
- Article: How to Change the Axle on your Boat Trailer Without Leaving your Driveway