Do Trailer Hangers Weld or Bolt On
Updated 02/19/2016 | Published 02/18/2016
Question:
I was looking at the single-axle trailer hanger kit for double-eye springs- 1-1/2inch front, 1-1/4inch rear code APS2. Ok now my question, do you have that available in a bolt-on? Thanks
asked by: Steve T
0
Expert Reply:
All of our double-eye trailer suspension hangers are designed to be welded on. Even if there are holes drilled in them they still need to be welded.
A qualified welder in your area would have no problem attaching them.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Single-Axle Trailer Hanger Kit for Double-Eye Springs - 1-1/2" Front, 1-1/4" Rear
- Trailer Suspension Parts
- Hangers
- Suspension Kits
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Double Eye Springs
- Single Axle
- etrailer
more information >
Continue Researching
- Q&A: Do Hangers Need to be Welded to Install
- Shop: Trailer Idler Axle Beam with Easy Grease Spindles - 60" Long - 2,000 lbs
- Shop: Dexter Trailer Axle Beam with EZ-Lube Spindles - 89" Long - 3,500 lbs
- Shop: Dexter Trailer Axle Beam with E-Z Lube Spindles - 86-1/2" Long - 5,200 lbs
- Shop: Trailer Axle Beam with Easy Grease Spindles - 86-1/2" Long - 5,200 lbs
- Shop: Front/Center/Rear Hanger for Double-Eye Springs - 3-1/4" Tall - 9/16" Bolt Hole
- Shop: Trailer Axle Beam with Easy Grease Spindles - 89" Long - 6,000 lbs
- Shop: Trailer Axle with Idler Hubs - 5 on 4-1/2 Bolt Pattern - 72" Long - 2,000 lbs
- Q&A: Do 10 Inch Kodiak Stainless Steel Disc Brakes Work With Oil Bath Hubs
- Article: Double-Eye Trailer Suspension System Review
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Where to Position the Trailer Axle?
- Article: How to Raise Your Travel Trailer Height
- Q&A: Comparing Different Hanger Kits ffor Single Axle Trailer with Double Eye Leaf Spring
- Article: How to Replace Trailer Leaf Springs in 5 Steps
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Q&A: How to Determine if Slipper Spring SP-177275 Will Fit Trailer
- Q&A: Do you Carry the Mounting Brackets to Line Up With the etrailer Single Axle Trailer Fender?
- Q&A: Recommended Double-Eye Suspension System for 2,000 lb Single Axle Boat Trailer
- Q&A: Do the Shackle Straps Go Inside or Outside the Leaf Spring Hanger