Troubleshooting Roadmaster Invisibrake that Doesn't Build Pressure
Published 11/10/2015
Question:
The air pressure is not maxing out it will loose pressure when traveling for long distances like 3 hours. Dealer install it and I have taken it back to them 3 times. My warranty is about to run out and I could use any help form invisible brake.
asked by: Kenneth
Expert Reply:
I spoke with my contact at Roadmaster and he told me that the first place to check is the vacuum line that leads to the engine. If that is kinked it will prevent it from building any pressure.
He did say that if you sit for long enough the pressure will eventually bleed off. So what you could be seeing is normal if the RV is sitting for an extended period of time.
Product Page this Question was Asked From
Roadmaster InvisiBrake Flat Tow Brake System - Preset
- Flat Tow Brake System
- Brake Systems
- Pre-Set System
- One-Time Setup
- Vehicle Battery
- Fixed System
- Power Assist Brake Compatible
- Air Brakes
- Hydraulic Brakes
- Indicator Lights
- Roadmaster
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Does Roadmaster Invisibrake Fit 2024 Jeep Rubicon
- Q&A: Will Curt RVibrake Shadow 2 Fit 2026 Ford Maverick Hybrid
- Q&A: Full Flat Towing Set Up For A 2026 Jeep Gladiator Sahara
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Recommended Parts for Flat Towing a 2025 Ford Maverick
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: Flat Towing Package for 2007-2018 JK Jeep Wrangler and Wrangler Unlimited
- Q&A: Flat Tow Setup for 2012 Jeep Grand Cherokee Overland
- Q&A: Recommended Flat Towing Set Up for a 2026 Ford Maverick Hybrid
- Q&A: Replacement RV Stereo for Magna Dyne M4-LCD
- Article: Must-Have Flat Towing Components
- Article: Trailer Wiring Diagrams
- Article: Flat Towing Package for 2012-2014 Honda CR-V
- Article: Flat Towing Package for 2020 Jeep Wrangler