Troubleshooting Trailer Lights That Have Power But Are Not Working
Published 10/29/2015
Question:
if u have power going to back of your trailer but it will not work on new taillight but u check the wiring come it work , could it the light ground on steel bumper the ate from canadian tire
asked by: Trevor Y
0
Expert Reply:
It sounds like you have power going back to the light, but the light is not working. This is typically an issue with the light ground. If you have the light grounded to the bumper, I recommend running the trailer light ground up to the main trailer ground.
If this does not provide a solution, let me know and I will be glad to look into further solutions for you.
expert reply by:
Victoria B
0
Product Page this Question was Asked From
16 Gauge, 4 Conductor Bonded Parallel Wire - Per Foot
- Wiring
- Wire
- Bonded Wire
- 4 Wire
- 16 Gauge
- Deka
more information >
Continue Researching
- Q&A: Recommended Front Hitch and TorkLift Tie Downs for a 2026 Ram 2500 Diesel w/a Factory Hitch
- Article: Trailer Wiring Diagrams
- Q&A: Recommended Built-In Convection Microwave to Replace a 0.9 Cu Ft Furrion Microwave Model FMSN09BL
- Q&A: Can A No-Drill Bracket Be Installed On A Hitch With A Square Crosstube?
- Q&A: Will The Optronics Flexible LED Light Strip UCL90CB Stick Under A Trailer/Camper?
- Q&A: Will TowSmart T-Connector Wiring Harness Fit 2016 Chevy Colorado
- Article: Trailer Lights Not Working After Winter? Test Truck or Trailer
- Q&A: Wiring Instructions for Derale Temperature Gauge
- Article: Trailer Lighting Requirements
- Article: How to Bleed Your Trailer Surge Brakes
- Q&A: Testing The Dexter Electric Over Hydraulic Brake Actuator
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Tell the Weight Rating of a Trailer Axle