Size of Socket on Electric A-Frame Tongue Jack # JET-3500 for Manual Operation
Published 10/28/2015
Question:
what size is the nut on the top of the jack
asked by: Robert R
0
Expert Reply:
The Electric A-Frame Tongue Jack # JET-3555 that you referenced has an override nut on the top of the jack that will take a 3/4 inch socket.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Stromberg Carlson Electric Trailer Jack - Drop Leg - A-Frame - 24" Lift - 3,500 lbs - White
- Camper Jacks
- Pop Up Camper
- Teardrop Camper
- Travel Trailer
- A-Frame Jacks
- Steel
- 3001 - 4000 lbs
- Electric Jack
- 24 Inch Lift
- Bolt-On
- Weld-On
- 1 Jack
- Stromberg Carlson
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Will the etrailer Electric Trailer Jack e23ZV Work w/a Jack-It Bike Rack?
- Q&A: Recommended Replacement Jack For Lippert Smart Jack With Damaged Buttons Causing Water To Get In
- Q&A: Alternative 7-Way Connector for the Kia R0F67 AC600 on a 2025 Kia Carnival
- Q&A: How to Wire Up and Install Electric A-Frame Tongue Jack, # JET-3500
- Q&A: Recommended Storage Cover for Lance 1475 Travel Trailer
- Q&A: Is There A Low Profile Electric Trailer Jack That Allows SUV Trunk To Open?
- Article: The Best Electric Trailer Jacks of 2025
- Q&A: What Weight Capacity of Tongue Jack is Needed for a 4,600 Pound Dry Weight Trailer
- Article: Holiday 2025 | RVers’ Favorite Gear & Road Picks
- Article: How to Measure for Trailer Hitch Drop
- Article: Can You Flat Tow a 2025 Cadillac Escalade?
- Article: How to Install an Electric Trailer Jack
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: Trailer Jacks