Estimated Install Time For Air Lift Loadlifter Air Helper Springs AL55FJ On 2020 Ford F-250
Updated 04/12/2021 | Published 04/08/2021 >
Products Featured in This Question
Question:
What is the approximate install time on the 7500xl for a 2020 F250 4x4?
asked by: Devin
Expert Reply:
To install the Air Lift LoadLifter 7500 XL Air Helper Springs - Rear Axle # AL55FJ on your 2020 Ford F-250 you can expect it to take between 3-5 hours if this is your first time installing one of these kits. While it is not a very difficult install, it is good to take your time to make sure you are routing the air lines in a mannor that keeps them away from moving parts and heat, and taking your time overall carefully following the instructions.
With basic tools and a weekend you will have no issues.
One thing I do recommend is also adding an on-board air compressor like the # AL25856 which will allow you to control the air pressure in each bag from the gauge inside of your truck instead of manually inflating the bags each time you are ready to tow a trailer or haul a heavy pay load.
I included written instructions and videos for you to take a look at.

Product Page this Question was Asked From
Air Lift LoadLifter 7500 XL Ultimate Air Helper Springs - Rear Axle
- Vehicle Suspension
- Towing/Load Leveling
- Air Springs
- Extra Heavy Duty
- Rear Axle Suspension Enhancement
- Air Lift
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Suspension Enhancement
- Search Results: air bag kit
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Q&A: Converting 3,500 lb Torsion Axle to Spring Leaf Axle on Boat Trailer
- Search Results: dexter 15k
- Search Results: 28682
- Search Results: 3984
- Shop: Replacement Oil Cap Kit for 9,000-lb to 15,000-lb Dexter Axle
- Shop: Timken Replacement Trailer Wheel Bearing - 3984
- Shop: Timken Replacement Trailer Wheel Bearing - 28682
- Shop: Dexter Trailer Hub Assembly for Heavy-Duty 15K Axles - 8 on 275mm Oil Bath
- Shop: Trailer Idler Hub Assembly for 10,000-lb Axles - 8 on 6-1/2
- Shop: Dexter Trailer Idler Hub Assembly for 12,000-lb Axles - 8 on 6-1/2 - Oil Bath
- Shop: Dexter Trailer Hub and Drum Assembly for Heavy-Duty 10K Axles - 8 on 6-1/2 - Oil Bath
- Q&A: Will Air Bag Suspension Enhancement Make Unloaded Truck Ride Quality Smoother
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Search Results: suspension enhancement
- Shop: Trailer Hitch
- Article: Trailer Wiring Diagrams
- Search Results: air bag compressor kit
- Shop: Trailer Wiring
- Q&A: Does Truck with 6-1/2 ft bed Have to Use Slider Hitch for Turning Clearance with Fifth Wheel Hitch
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Stability Control for Heavy Duty Vehicles
- Shop: Brake Controller
- Search Results: air bags
- Q&A: 7-Way Trailer Plug Adapter or Compatibility with Lance Slide-In Truck Bed Camper
- Video: Choosing the Right Vehicle Suspension Upgrades
- Article: RV Sway Control, Stabilization, and Suspension Enhancement
- Shop: Gooseneck Hitch