Size of Install Bolts Used for Hitch on a 2007 Jeep Liberty
Published 10/07/2015
Products Featured in This Question
Question:
I have a Curt hitch on my 2007 Jeep Liberty. Some of the bolts fell out. What size are they so I can buy new ones?
asked by: Terri
0
Expert Reply:
The install bolts for the Curt Hitch part # 13044 that you would have installed on your 2007 Jeep Liberty are M12-1.75 x 35mm. Be sure to tighten the new bolts to the recommended torque figure that is in the install instructions link I attached.
To order all of the install hardware from us you could order part # RHK. You will need to select the hitch manufacturer from the drop down menu and enter the part number for the hitch as well.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- For Towing
- Class III
- 500 lbs TW
- 5000 lbs GTW
- 2 Inch Hitch
- Concealed Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Shop: Trailer Wiring
- Shop: Hopkins Plug-In Simple Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Q&A: Bolt Size that Comes with Curt Hitch for 2006 Jeep Liberty
- Q&A: Replacement For 11-1/2" Slipper Spring Equalizer
- Q&A: Availability Of Replacement Bearings 28580, 25580, and Oil Seal 370352 For AL-KO 10,000lb Axle
- Q&A: What are the Dimensions of a #99 Spindle
- Q&A: Replacement Caliper Solution for Tie Down Engineering 46304
- Q&A: 2013 Toyota Sienna Hitch Recommendation for Yakima EXO System
- Article: 5 Things to Know About Weight Distribution Hitches
- Q&A: Can Gas Tank/Propane Tank be Carried on etrailer Hitch Cargo Carrier