Replacement For 11-1/2" Slipper Spring Equalizer
Updated 10/14/2024 | Published 10/05/2024
Products Featured in This Question
Question:
I see you have 11 inch and 12 inch equalizers but I measure the equalizer on my trailer to be 11.5 inches. Since I don’t see the measurements from one hole to the other is not listed I’m not sure either of your products will work. Is there other information to help me decide if I can make it work? Or, do you have any suggestions?
asked by: Ryan
Expert Reply:
Hi Ryan; I have attached a diagram below of the # TREQ1304 for your reference. Go ahead and compare these measurements to your current equalizer. If the distance between the holes lines up with yours this is what I would choose. The # APT6SE equalizer doesn't have measurements listed so I can't add a diagram right now. I can measure one in our warehouse tomorrow and add it here for you to compare. If neither of them lines up perfectly I would choose whichever is closer.
(click to enlarge)
(click to enlarge)
Product Page this Question was Asked From
Tandem-Axle Trailer Hanger Kit for 2" Slipper Springs - 12" Long Equalizers
- Trailer Suspension Parts
- Hangers
- Suspension Kits
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Slipper Springs - 2 Inch
- Tandem Axle
- etrailer
more information >
Continue Researching
- Search Results: trailer suspension parts
- Shop: Equalizer for 2" Wide Slipper Springs - 11" Long - 7/8" Center Hole
- Shop: Tandem-Axle Trailer Hanger Kit for 2" Slipper Springs - 12" Long Equalizers
- Search Results: spring shackle
- Shop: Spring-Eye Bolt with Locknut for Slipper Springs - 3-1/2" Long
- Shop: Equalizer for 2" Wide Slipper Springs - 12" Long - 7/8" Center Hole
- Search Results: equalizer
- Search Results: trailer safety chains
- Search Results: nylon bushing
- Search Results: plastic bushing
- Search Results: leaf spring bushing
- Shop: Wet Equalizer Bolt with Castle Nut and Grease Zerk - 4-11/16" Long - 7/8" Diameter
- Shop: Terran Industries Tandem-Axle Hanger Kit for Slipper Springs 3-3/4" Tall Front
- Video: Review of Terran Industries Trailer Suspension Parts - Tandem-Axle Hanger Kit - TX85VJ
- Shop: Dexter Tandem-Axle Trailer Hanger Kit for 2" Slipper Springs - 38" Axle Spacing
- Q&A: Slipper Spring Hanger Positioning for 7,000 lb Tandem Axle
- Video: Equalizer for 2" Wide Slipper Springs: The Breakdown
- Video: Installation of the TruRyde Equalizer for 2" Wide Slipper Springs
- Video: Equalizer Bolt with Cotter Pin and Castle Nut: The Breakdown
- Shop: Trailer Hitch
- Video: All You Need to Know About the Tandem-Axle Trailer Hanger Kit for 2" Slipper Springs
- Video: The Low-Down on the Equalizer for 2" Wide Slipper Springs
- Video: Checking Out the Front Hanger for 2" Wide Slipper Springs
- Q&A: What Replacement Hardware do I Need to Use with My Slipper Springs # # SP-161275?
- Q&A: Parts Needed For Reducing 7,000LB Leaf Springs On a 2021 Keystone Carbon From Flattening
- Shop: Trailer Wiring
- Q&A: Can Trailer Tire 215/75-17.5 be Replaced with 235/75-17.5
- Article: How to Measure a Trailer Axle
- Q&A: Hanger Spacing when Using 12 Inch Long Slipper Spring Equalizer E4541-Z
- Q&A: How to Measure to Determine the Size Trailer Brakes Needed For Hydraulic Drum Replacement
Ryan
10/8/2024
Thanks for the info, could you measure the other one too like you mentioned. I was planning on doing just what you recommended, compare the two and see which is closest to what I have. Thanks