Can the Trailer Clearance Light part # MC53RB be Flush Mounted
Published 09/30/2015
Products Featured in This Question
Question:
looking for a way to flush-mount this light. am using with 4 inch round grommet mounted 435800 tail lights would like it to have the same profile.. can this be done or do you have another 2inch light to suggest. i dont want it to stick out of the grommet..by the way,
asked by: Tony
0
Product Page this Question was Asked From
Optronics Trailer Clearance and Side Marker Light - Submersible - Incandescent - Round - Red Lens
- Trailer Lights
- Clearance Lights
- Marker
- Round
- Recessed Mount
- Submersible Lights
- Incandescent Light
- 2 Inch Diameter
- Red
- Optronics
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Comparing Kenda KR03, KR35, And KR53 Tires
- Q&A: Installation of the Brake Buddy Classic 3, How to Provide Power
- Q&A: How To Wire Brake Buddy Battery Charger 39339
- Q&A: Is The Diameter Of The Eye On The e29FV Leaf Spring 9/16 Or 3/4?
- Q&A: Best 7-Way Wiring Harness For 2017 Honda Pilot
- Q&A: Replacement Swivel Jack for 2005 EZ Loader Boat Trailer
- Q&A: Bearing Replacement Recommendation for Timken 07100
- Article: Trailer Lighting Requirements
- Article: Snow Tire Chain Overview: How to Buy the Right Tire Chains
- Article: How to Install E-Track in 3 Easy Steps
- Article: Trailer Maintenance Schedule
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)