Why Is Kodiak Disc Brake Kit # K2HR35D-8 Limited To 13 Inch Wheels
Updated 09/29/2015 | Published 09/28/2015 >
Products Featured in This Question
Question:
Is there any reason these wont work with 14inch or wheels?
asked by: Nate
Expert Reply:
The reason the Kodiak Disc Brake Kit, part # K2HR35D-8 is limited to 10 inch to 13 inch wheels is because of the hub surface.
My contact told me that the rotor size at 8 inches would not have enough mating surface for the wheel and can cause it to wobble if too large of a wheel is installed on the hub. The bolt pattern may be the same but the hub is not designed for a larger wheel.
If you have a 14 inch wheel and it has a 5 on 4-1/2 bolt pattern I recommend part # K2HR35D. This uses the same size inner and outer bearings as the # K2HR35D-8 system but is designed for wheels that are 13 inches or larger because it has a larger hub.
Product Page this Question was Asked From
Kodiak Disc Brake Kit - 8" Rotor/Hub - 5 on 4-1/2 - Dacromet - 3,500 lbs
- Accessories and Parts
- Trailer Brakes
- Disc Brakes
- LH
- RH
- 3500 lbs
- Brake Assembly
- 5 on 4-1/2
- Hub and Rotor Assembly
- Kodiak
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Upgrading 8" Hydraulic Brakes to Disc That Will Fit a 10" Wheel and Tire
- Q&A: Electric Brakes for 10 Inch Wheels
- Q&A: How to Add Hydraulic Drum or Disc Brakes to a Pontoon Boat Trailer
- Q&A: Replacement Brake Setup for Trailer with DB-42 Disc Brakes
- Q&A: Disk Brakes Compatible with 4400 lb Axle
- Q&A: Hydraulic Disc or Drum Trailer Brakes for 10 Inch Wheels
- Q&A: Replacement Hub / Disc Brake Kit For EZE-TOW Tow Dolly With 5 On 4-1/2
- Article: Best Boat Trailer Jacks
- Article: How to Raise Your Travel Trailer Height
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: Adding Electric Over Hydraulic Disc Brakes
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: Trailer Lighting Requirements

