What is the inner Diameter of Replacement Lift Handle for Curt Weight Distribution Systems
Updated 09/16/2015 | Published 09/15/2015
Question:
I have an EAZ Lift Elite round bar weight distrubution hitch. The dealer who installed it provided a hook up bar. I would like to have a spare. I ordered EAZ LIft part number 48031 and it was about 1 mm too small in diameter. Would this Curt bar work? What is the diameter of the hole in the bar?
asked by: Stephen P
Expert Reply:
I went out to the warehouse and pulled a Replacement Lift Handle for Curt Weight Distribution Systems # C17112 to measure the inner diameter. It was 0.76 inches so just a hair over 3/4 of an inch.
This measurement on this and many handles can vary ever so slightly because of the powder coating. That might be why the handle you bought didn't fit (if it is a painting or coated handle).
Product Page this Question was Asked From
Replacement Lift Handle for Curt Weight Distribution Systems
- Accessories and Parts
- Weight Distribution Hitch
- Tools
- Lift Tool
- CURT
more information >
Continue Researching
- Q&A: Replacement Hook Up Brackets for a 48069 Eaz Lift Weight Distribution Hitch
- Q&A: Can You Combine 2 of the Go Power Portable Solar Panel Kits
- Q&A: Replacement Caliper Solution for Tie Down Engineering 46304
- Q&A: Trailer Hitch Receiver Compatible With Hands Free Lift Gate On a 2022 Buick Encore GX
- Article: RV Roof Types: What Type of Roof Does My RV Have?
- Article: How to Replace a Rubber RV Roof
- Article: The #1 RV Roof Maintenance Tip: Keep it Clean (Here's How)
- Article: RV Sway Control, Stabilization, and Suspension Enhancement
- Q&A: Availability Of Replacement Camera For Furrion Vision S Camera System
- Q&A: Replacement Light Lens Solution for Lippert Powered A-Frame Trailer Jack 285318
- Q&A: Spring Bar Lift Tool Recommendation for Reese Weight Distribution