Recommended Plug-In Adapter For Hopkins Brake Controller On 2013 Ford F-150
Published 08/14/2015
Question:
Is anything needed after installing HM47297 brake controller on 2013 F-150
asked by: Paul K
1
Helpful Expert Reply:
When installing the Hopkins InSIGHT Flex-Mount Trailer Brake Controller HM47297 on your 2013 F-150, you only need the additional plug-in adapter, part # HM47845 to complete the installation.
You plug one end of the adapter into the back of the brake controller and the other end into the brake controller port located under the dash just to the right of the steering column.
expert reply by:
Jeffrey L
1
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: 5 Things to Know About Weight Distribution Hitches
- Q&A: Best Way to Prevent Sagging Suspension When Towing a Trailer
- Q&A: How to Tow a 2013 Toyota Prius V Behind a Motorhome
- Q&A: Brake Controller Wiring for Ford E-450 Motorhome
- Q&A: Roof Rack and Board Carrier Recommendation for 2016 Toyota Prius V with Glass Roof
- Article: Brake Controller Installation on a Ford Full-Size Van
- Q&A: Brake Controller and 7-Way Trailer Connector Installation on 2013 Ford E-350 Van
- Q&A: Locating the Brake Controller Connector on a 2017 Ford F-150 to Install the Hopkins # HM47294
- Q&A: Location of Brake Controller Connector on 2005 Ford F150
- Article: Brake Controller Installation: Starting from Scratch
- Article: Trailer Wiring Diagrams
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: How to Install a Brake Controller on Chevrolet / GMC 1999-2006 Pickups