What Are Center To Center Dimensions Of Mounting Holes On Peterson Trailer License Plate Light
Updated 07/29/2015 | Published 07/28/2015
Question:
What is the mounting hole dimension center on center? Thanks!
asked by: Adam C
1
Helpful Expert Reply:
The mounting holes on the Peterson Sealed, Trailer License Plate Light, part # M439K are 2-3/4-inches center-to-center. I have attached a photo of the light with the mounting dimensions noted.
This light has a polycarbonate lens and is sonic welded for a watertight seal and also includes the wiring plug.
expert reply by:
Jeffrey L
1
click to enlarge
Product Page this Question was Asked From
Peterson Trailer License Plate Light - Submersible - Incandescent - Gray Housing - Clear Lens
- Trailer Lights
- License Plate Lights
- Rectangle
- Surface Mount
- Submersible Lights
- Incandescent Light
- 3-3/8L x 1-3/4W Inch
- White
- Peterson
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: How to Choose a Trailer Hitch Coupler
- Article: Trailer Wiring Diagrams
- Article: How to Tell the Weight Rating of a Trailer Axle
- Q&A: Recommended Replacement Hubs for a Tiedown 11029 Boat Trailer
- Q&A: Looking for a Trailer License Plate Light that is Submersible
- Q&A: How to Find Replacement for TDE 11029C Hub Assembly
- Q&A: What to Do if the Peterson License Plate Light M439K Burns Out its Bulb
- Q&A: Recommended Backing Plate for the Square D-Ring Tie-Down Anchor ABS69FR
- Q&A: Mounting Hole Spacing For Square D-Ring Tie-Down Anchor ABS69FR
- Q&A: Should an Electric Trailer Jack Run Off of a Trailer Breakaway Battery
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: How to Install E-Track in 3 Easy Steps