Installing Brake Controller Wiring Adapter Part # 3035P on 2004 Ford Expedition
Updated 05/24/2010 | Published 05/21/2010
Question:
2004 ford expedition cannot find the plug that is shown on how to for Factory Installed 4-Way labeled picture B. my 4-way pin does have an extra wire taped up but not connected by the 4-way . need to know if there is actually a plug as in picture . Then I will Know what to order. Thanks
asked by: Michael m
Expert Reply:
The connection point for the brake controller should be located under the dash just above where where your right leg would be if you were behind the wheel.
I have an installation video that shows the location of the connector. The video shows an install on a 2007 Expedition, but the procedure would be similar on your 2004 model. The connector you are looking for is gray in color.
Product Page this Question was Asked From
Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers - Ford, Lincoln, Mercury
- Accessories and Parts
- Trailer Brake Controller
- Wiring Adapter
- Plugs into Brake Controller
- Vehicle Specific
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Brake Controller Installation on a Ford Full-Size Van
- Q&A: Installation Time for Blue Ox BX1128 Flat Tow Base Plate Kit for 2016 Jeep Grand Cherokee
- Q&A: Brake Controller Wiring for Ford E-450 Motorhome
- Q&A: What is the Difference Between the Tekonsha Prodigy P2 and the P3 Brake Controllers
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: What Charger Can I Use To Charge an AGM Onboard Battery
- Q&A: Lift Kit For 3,300 lb Dexter Torsion Axle On A 2014 Lance Trailer
- Q&A: Brake Controller Connector Location on a 2020 Ford Explorer
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Q&A: Recommended Redarc Tow-Pro Liberty Brake Controller and Mounting Panel for a 2024 Nissan Frontier
- Article: How to Measure for Trailer Hitch Drop
Mike L.
5/24/2010
The connection point for the brake controller should be located under the dash just above where where your right leg would be if you were behind the wheel. I have an installation video that shows the location of the connector. The video shows an install on a 2007 Expedition, but the procedure would be similar on your 2004 model. The connector you are looking for is gray in color.