Max Height For Trailer Lynx Levelers

Updated 07/13/2015 | Published 07/10/2015

Products Featured in This Question

Ultra-Fab Ultra Scissor Jacks - 24" Lift - 13,000 lbs - Qty 2

(716)

$115.20

Ultra-Fab Stackable Stabilizers for Small Trailers and Campers - 6,000 lbs - Qty 4

(316)

$84.11

Question:

I have a Sprinter Campervan that I would like to level on my sloped driveway. Ideally, I believe it would require about 8 inch lift on one side and 10 inch lift on the other. The driveway is sloped both north and south and east-west. I currently use Rhino Ramps 16,000 LB capacity, but they have max lift of 6 inches. It seems scissor jacks would work, but I need something that does not permanently mount to the Sprinter Chassis. Can Lynx Levelers be stacked to give 8-10 inch lift? Suggestions? Thanks,

asked by: Roger

Helpful Expert Reply:

I spoke to my contact at Lynx and he informed me that the part # 77433 that you referenced can be stacked up to 5 blocks tall and since each block is 1 inch tall that would mean that you could get a max of 5 inches.

The height you are looking for leaves you in an area without a good solution if you do not want something permanently mounted to your trailer. If your trailer was a bit taller you could go with the # UF48-979004 as it can provide 11 to 17 inches of height support.

The only solution I could recommend is a scissor jack setup like the part # UF48-979002.

expert reply by: Jameson C