Availability of Cargo Trailer Strap Hinge with Mounting Hole Spacing of 4-1/4-Inches
Updated 06/25/2015 | Published 06/23/2015
Products Featured in This Question
Question:
Im needing a Strap hinge for cargo trailer that has a distance between holes of 4.25 in. Any ideas?
asked by: Michael P
Expert Reply:
I checked the dimensions of all of the strap hinges we offer; all can be seen on the linked page. One of these, Redline part # 2512, did not have the mounting hole spacing noted on the product page so I pulled one from stock so that I could get that information for you. The hole spacing is noted on the linked photo that I have prepared for you. None of these hinges has the exact spacing you're looking for, I'm afraid.
If you do end up using an alternate part and have to drill a new hole or two you can seal up the extra holes with a product like Loctite # LT37467 (black) or # LT37464 (grey).
Product Page this Question was Asked From
Square Corner Hinge with Reverse Bracket - 12" Long - 270 Degree Rotation - Zinc Plated
- Trailer Door Hinges
- Strap Hinge
- Non-Removable Pin
- Steel
- 12 Inch Long
- 2 Inch Wide
- Bolt-On
- Polar Hardware
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Will P&F Products H-Channel Frame for Enclosed Trailers Fit Over 1 inch Channel
- Q&A: How To Choose The Correct Leaf Springs For My Trailer
- Q&A: Replacement LED Trailer Tail Lights For Wesbar 102641
- Q&A: How to Replace Tie Down Engineering LP7000 Actuator
- Q&A: Thumb Latch Cylinder Measurements
- Q&A: Owners Manual for the Hopkins Agility Trailer Brake Controller HM47295
- Q&A: Troubleshooting Hopkins Impulse Trailer Brake Controller Error Message OE
- Article: Trailer Wiring Diagrams
- Article: Trailer Lighting Requirements
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers