U-bolts for Gooseneck Trailer hitch Safety Chains
Updated 05/18/2015 | Published 05/16/2015
Products Featured in This Question
Question:
I am in need of the ubolts for a 5thwheel gooseneck adaptation. The hole in the ball hitch underframe are 2inch center to center hole. I drilled through the bed, but am still inneed or the ubolts? Can you help. 5th wheel is 12000 to 14000 lbs. Thank you for your time.
asked by: Garry
0
Expert Reply:
U-bolts for gooseneck hitches have springs on them so that the retract down when not in use. U-bolt kit # C113 sounds like it would work for you with the measurements you have provided. The u-bolts are 2 inches wide on center and the springs, washers, and nuts are included.
expert reply by:
Michael H
0
Product Page this Question was Asked From
2" Square Trailer U-Bolt (Qty 2)
- Trailer Suspension Parts
- U-Bolts
- Camper
- Car Hauler
- Utility Trailer
- 3500 lbs
- Square Axle - 2 Inch
- 9/16 Inch Diameter
- 5-3/4 Inch Long
- Redline
more information >
Continue Researching
- Article: How to Accurately Measure Trailer Leaf Springs
- Q&A: Correct Replacement for 26-1/2 Long Leaf Spring
- Q&A: How To Flip Square Trailer Axle For Ground Clearance
- Q&A: What is the Spacing Between the Front Hanger and Rear Hanger for 27" Leaf Spring Single Axle Trailer
- Q&A: Will Dexter Trailer Hub and Drum Assembly # 84546UC3-EZ Fit Inside a 13 Inch Wheel
- Q&A: Installation of Slipper Spring with Open Eye End
- Q&A: Keel Pads For Crossmember On a ShoreLander Boat Trailer
- Q&A: Will the Yates Keel Pad # YR1203SY Fit on a Crossmember with a Bend
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: Where to Position the Trailer Axle?
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: Double-Eye Trailer Suspension System Review
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)