What Size Mounting Hardware is Needed for Trailer D-Ring Tie Down # LRB1
Updated 05/04/2015 | Published 05/02/2015 >
Question:
Concerning your Trailer D-Ring Tie Down, Bolt On 2-1/2inch x 2-3/8inch Surface Mount, do you sell reenforcement plates, bolts, lock washers, and nuts for it? Thank you for the assist.
asked by: Ray E
0
Expert Reply:
According to my measurements the mounting holes on the Trailer D-Ring Tie Down, # LRB1, will accept bolts no larger than 7/16 inches in diameter so you could go with a 3/8 inch bolt/nut or screw. You can just use standard hardware which can be obtained from your local hardware store.
We do not offer any hardware for these tie downs.
expert reply by:
Leah S
0
Product Page this Question was Asked From
Brophy D-Ring Tie Down Anchor - Bolt-On - 2-3/8" Wide - Surface Mount - 4,000 lbs
- Trailer Tie Down Anchors
- D-Rings
- Universal
- Zinc-Plated Steel
- 4000 lbs
- Bolt-On
- Folding
- Surface Mount
- Brophy
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: What's the difference between the Standard Torx Trailer Screw and the Torx ACQ Treated wood screw?
- Q&A: Recommendation for Re-Using Deck Board Screw Holes When Replacing Wood on Trailer
- Q&A: How Long Is Battery Life On PingMaster Trailer Tracker Device?
- Q&A: Where Does Replacement Spring part # CA-5196-SPR Install on Coupler
- Q&A: Difference Between Brophy Swivel D-Ring Anchors # RR6K and # RR06
- Q&A: How To Power Third Brake Light On Camper Shell Using 7-Way Trailer Connector
- Q&A: Comparing O-Track Cargo Control System And L-Track System
- Article: How to Measure for Trailer Hitch Drop
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Cargo Tie-Down Methods
- Article: Converting Your RV Water Heater to Tankless
- Article: Trailer Wiring Diagrams
- Article: Trailer Maintenance Schedule
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers


