Should Loctite be Used when Install Trailer Suspension Parts
Published 04/29/2015 >
Question:
Hello, Could not find the answer. Anyways, when tightening the bolts for all suspension pieces, is it necessary/recommended to use lock tight? Personally, I would not think so, those nuts seems to be pretty hard to back out of the bolt, but I wanted to make sure first before the trailer takes its maiden voyage. Code: APT5
asked by: Ryan
Expert Reply:
I would not use any Loctite when installing suspension components on a trailer since the suspension components need to be able to move relatively freely. I would be afraid of getting the thread locker on bolt or something away from the threads. If you were to use a thread locker then use the blue kind. The red is way too strong. The blue will allow nuts and bolts to be removed with hand tools. Maybe I'm just paranoid but for me, I wouldn't use it.
Product Page this Question was Asked From
Tandem-Axle Trailer Hanger Kit for Double Eye Springs - 3-1/4" Tall Front/Center/Rear
- Trailer Suspension Parts
- Hangers
- Suspension Kits
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Double Eye Springs
- Tandem Axle
- etrailer
more information >
Continue Researching
- Search Results: nylon bushings trailer leaf springs
- Search Results: leaf spring hangers
- Search Results: trailer suspension parts
- Search Results: nylon leaf spring bushings
- Search Results: trailer leaf spring shackles
- Shop: Shackle Strap - 3-1/8" Long
- Search Results: 10~9 grease seal
- Video: Feature Review Dexter Single Axle Heavy Duty Suspension Kit
- Shop: Nylon Bushing - 9/16" Inner Diameter, 11/16" Outer Diameter - 1-3/4" Long
- Video: Checking Out the Shackle Strap
- Video: Detailed Breakdown of the Dexter Single Axle Heavy Duty Suspension Kit
- Video: Detailed Breakdown of the Shackle Strap
- Shop: Dexter Single Axle Standard Duty Suspension Kit - Double Eye Springs
- Shop: Replacement Shackle Strap - 2-5/8" Long
- Search Results: slipper spring bushing
- Shop: Grease Seal - Double Lip - I.D. 1.500" / O.D. 1.987" - 2,000-lb to 2,500-lb Axles - Qty 1
- Shop: Replacement Trailer Wheel Bearing - L44649 - Qty 1
- Shop: Replacement Bearing Kit with Bearings L44649, Races L44610, Seal 10-9 - Fits 1.063" Spindles
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Trailer Lighting Requirements
- Shop: Trailer Wiring
- Shop: Vehicle Lights
- Q&A: Replacement Bearings for 2010 Triton XT12-101
- Q&A: Bearings Seem Loose on Strait Trailer Spindle
- Q&A: Should Trailer Bearings Spin on the Spindle they are Installed On
- Q&A: Should Thread Locker be Used when Installing Trailer Suspension U-bolts
- Q&A: Replacement Bearings, Races, Seals, and Brakes For a Dexter D35 and D44 Axle
- Q&A: Troubleshooting Trailer Bearings that Fit Almost Too Tight to Install
- Q&A: How To Choose Correct MORryde Shackle Upgrade Kit
- Article: Trailer Wiring Diagrams

