Removing Curt T-Connector Vehicle Wiring Harness # C56170 from 2013 Honda Pilot to Install on 2014
Updated 04/29/2015 | Published 04/28/2015
Question:
Part number CURT 56170 I need to remove the harness from the inside compartment of a 2013 Honda pilot. Is there a special trick to get the connectors to release? I dont want to break the connectors...
asked by: Ray K
1
Helpful Expert Reply:
On the vehicle side of the connector there should be a small tab that will need to be slightly lifted, which typically can be done with a very small screwdriver, while pulling the two connectors apart.
expert reply by:
Leah S
1
Product Page this Question was Asked From
Curt T-Connector Vehicle Wiring Harness for Factory Tow Package - 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Vehicle End Connector
- Powered Converter
- Factory Tow Package
- 4 Flat
- Plug and Lead
- Plug-In
- Hidden
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Trailer Wiring
- Shop: Curt T-Connector Vehicle Wiring Harness for Factory Tow Package - 4-Pole Flat Trailer Connector
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Option For Replacing Failing Brake Buddy Vantage 3
- Q&A: Availaiblity of White Half Moon Trailer Vent
- Q&A: Does Trailer Hitch for 2008 Honda Pilot Come with Everything
- Q&A: Locating Wiring Connector On 2012 Honda Pilot On Driver's Side Rear Cargo Area
- Q&A: Trailer Wiring Harness for 2014 Honda Pilot
- Q&A: Replacement Grease Seal for GS-1250DL
- Q&A: Recommended Trailer Wiring Harness For 2014 Honda Pilot
- Article: How to Choose the Right Trailer Hitch Class
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Brake Controller Installation: Starting from Scratch
- Article: How to Measure a Boat Trailer Axle
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)