Passenger Turn Signal Does Not Work and Brakes are Dim when Applied
Updated 04/16/2015 | Published 04/15/2015
Question:
Is this a ground problem? Or what could be the problem?
asked by: Danny
0
Expert Reply:
This does sounds like a ground issue. You will want to check on the trailer lights that the ground is secured to clean, bare metal. You might also want to check for corroded connections. Look for wires with worn or cracked insulation, or wires that are pinched or broken.
expert reply by:
Chris O
0
Product Page this Question was Asked From
16 Gauge, 4 Conductor Bonded Parallel Wire - Per Foot
- Wiring
- Wire
- Bonded Wire
- 4 Wire
- 16 Gauge
- Deka
more information >
Continue Researching
- Q&A: Recommended Front Hitch and TorkLift Tie Downs for a 2026 Ram 2500 Diesel w/a Factory Hitch
- Article: Trailer Wiring Diagrams
- Q&A: Recommended Built-In Convection Microwave to Replace a 0.9 Cu Ft Furrion Microwave Model FMSN09BL
- Q&A: Can A No-Drill Bracket Be Installed On A Hitch With A Square Crosstube?
- Q&A: Will The Optronics Flexible LED Light Strip UCL90CB Stick Under A Trailer/Camper?
- Q&A: Will TowSmart T-Connector Wiring Harness Fit 2016 Chevy Colorado
- Article: Trailer Lights Not Working After Winter? Test Truck or Trailer
- Q&A: Wiring Instructions for Derale Temperature Gauge
- Article: Trailer Lighting Requirements
- Article: How to Bleed Your Trailer Surge Brakes
- Q&A: Testing The Dexter Electric Over Hydraulic Brake Actuator
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Tell the Weight Rating of a Trailer Axle