Weight Distribution System Recommendation for a 2015 Toyota Tundra Towing Boat Trailer
Updated 04/08/2015 | Published 04/07/2015 >
Question:
I need a weight distribution system with sway control for a 2015 Toyota Tundra towing a 9500 lbs boat trailer with a tongue weight of about 750lbs. Im looking at the Blue Ox, but Im not sure. I need a system that will be relatively easy to connect and disconnect the trailer from the truck since I will be doing this every time I use the boat. So my questions are: 1 How easy is it to connect and disconnect these systems? 2 Can I just leave the system connected to the trailer and disconnect the truck? 3 Do these system really weight 100lbs? Thanks for your response!
asked by: John S
Expert Reply:
The best way to pick out a weight distribution system is to base it off of the loaded tongue weight of the setup when it is loaded and ready to tow. This figure also includes the weight of any cargo behind the rear axle of the tow vehicle. I attached a help article on determining tongue weight for you to check out as well. You will want the loaded tongue weight of your setup to fall right in the middle of the tongue weight range of the system you use.
If your loaded tongue weight is 750 lbs, the # BXW1003 would be rated a bit too high. Also, if you are looking for an easy to install and use setup I wouldn't go the Blue Ox route. For an easier to use system I would go with a Reese system like the # RP66542 that would do great with your 750 lb tongue weight. The snap up brackets of this system are much easier to use than the Blue Ox ones.
The snap up brackets can be left on the trailer, but the rest of the system will have to be disconnected as it inserts in the trailer hitch. To disconnect the system the spring bars will have to be lowered so that the tension in the system is relieved which will allow the coupler to separate from the ball mount.
This system weighs 80 lbs.
Product Page this Question was Asked From
Blue Ox SwayPro Weight Distribution w/ Sway Control - 2" Hitch - Underslung - 10K GTW, 1K TW
- Weight Distribution Hitch
- WD With Sway Control
- Trunnion Bar
- Fits 3 Inch Frame
- Fits 4 Inch Frame
- Fits 5 Inch Frame
- Fits 6 Inch Frame
- Includes Shank
- 2-5/16 Inch Ball
- Fits 2 Inch Hitch
- Allows Backing Up
- 900 lbs
- Blue Ox
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: What is Difference Between Overslung and Underslung Trailer Coupler
- Q&A: Difference Between Underslung and Overslung Coupler For Weight Distribution System
- Q&A: Replacement Head and Spring Bars For 20k Blue Ox SwayPro
- Article: 5 Things to Know About Weight Distribution Hitches
- Q&A: Correct Blue Ox SwayPro for Trailer with 1,330 lb Dry Tongue Weight
- Q&A: Does the 30 Amp Go Power PWM Solar Charge Controller GP76QR Display Watts Produced?
- Q&A: Rockstar Mud Flaps For 2022 Ford F-350 Dually
- Q&A: Does the Blue Ox SwayPro Weight Distribution System Count as Tongue Weight
- Article: Top Weight Distribution Hitches for a Buttery Smooth Ride
- Article: How to Measure for Trailer Hitch Drop
- Article: Which Sway Control Hitch is Right For Your Trailer?
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Article: Determining Trailer Tongue Weight
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer




