Recommended Ball Mount for a Setup that Needs 1-3/4 inch Rise
Published 02/26/2015 >
Products Featured in This Question
Question:
Using your website to determine the correct ball mount size, I calculated I need a class III mount with a1-3/4inch rise but there are none matching that size, what is an alternate rise that will work ok?
asked by: Dan
Helpful Expert Reply:
For a ball mount that will give you the correct amount of rise for your setup you would want the Curt Ball Mount part # C45270. This has a 2 inch rise which would work well for you when you consider that with the tongue weight of your trailer on the hitch the rear suspension will most like sag slightly which would allow your trailer to sit perfectly level.
If you need a pin and clip part # F-4 would be what to use. Or for a locking hitch pin # e98880. For a 2 inch hitch ball you would want # 40038, or for a 1-7/8 inch ball # C40017.
Product Page this Question was Asked From
Curt Class III Drawbar - 2" Rise - 4" Drop - 13" Long - 7,500 lbs
- Trailer Hitch Ball Mount
- Fixed Ball Mount
- No Ball
- Steel Shank
- Drop - 4 Inch
- Rise - 2 Inch
- Fits 2 Inch Hitch
- 7500 lbs GTW
- CURT
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Can The Curt Ball Mount C45042 Be Used In The Rise Position?
- Q&A: Is it Better to Go with Higher or Lower Rise Ball Mount than Needed
- Q&A: Recommended 2" Ball Mount to Clear the Spare Tire on a Jeep Wrangler
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Availability of SnapPad Leveling Blocks
- Q&A: How Do I Know How Much of a Drop I Need on an Adjustable Hitch for Travel Trailer?
- Q&A: Recommended Hitch for a 2005 - 2015 Nissan Xterra
- Q&A: Extra Long Ball Mount with Rise and Drop
- Article: Hitch Anti-Rattle Devices: The Ultimate Guide
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Article: Troubleshooting Brake Controller Installations
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: How To Measure And Replace Everything In Your Hub Assembly


