Grease Cap Recommendation for a Hub with 55 mm Bore
Published 02/24/2015
Question:
can you supply me with axle grease cover caps size diameter approx 55mm for a box trailer axle 2of or a size no less than 50 this is an old trailer thanking you kk/pwr
asked by: Peter W
1
Helpful Expert Reply:
55 mm is right at 1.968 inches, so the correct grease cap you would need would be the Bearing Buddy part # BB1968SS.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
Bearing Buddy Bearing Protectors - Model 1968SS - Stainless Steel (Pair)
- Trailer Bearings Races Seals Caps
- Caps
- Bearing Protector Grease Cap
- 1.96 Inch
- 2000 lbs Axle
- 3500 lbs Axle
- Bearing Buddy
more information >
Continue Researching
- Q&A: Bearing Buddy Recommendation for Hub Bore of 1.97 inches
- Q&A: Solution for Needing Replacement Caliper for Kodiak 204 Caliper
- Q&A: What is Next Size Smaller Bearing Buddy than One with 1.98 inch Outer Diameter
- Q&A: Wet Bolt Recommendation For the Roadmaster Comfort Ride Leaf Spring Suspension Kit
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Q&A: Replacement Electric Trailer Brakes for a Dexter 8-249 Hub
- Article: Printable Trailer Bolt Hole Pattern Template
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Q&A: Bearing Buddy Bearing Protectors For a 1.96" Hub Inside Diameter
- Q&A: Are The DeeMaxx Hub/Rotor Assemblies Compatible With Kodiak 225 Calipers?
- Article: How to Replace or Install an RV Roof Vent
- Article: How to Replace an RV Roof Vent Cover
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?