Brake Controller Recommendation for a 2005 Ford Excursion V10
Published 02/05/2015
Products Featured in This Question
Question:
Will this install on the above truck? Do I need any other adapters? I am towing a double axel travel trailer. T.y. For your help.
asked by: Chuck B
0
Expert Reply:
Yes, the Curt Brake Controller part # C74VV that you referenced has been confirmed to fit your 2005 Ford Excursion. All you need to install it is the correct harness, part # C51322.
This adapter plugs into the port on your vehicle's built-in brake control wiring harness. This harness should be located beneath the dash, near the center console.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Curt Venturer NEXT Trailer Brake Controller - Up to 3 Axles - Time Delayed
- Trailer Brake Controller
- Time Delayed Controller
- Electric
- Electric over Hydraulic
- Plug-In
- Under-Dash Box
- Under-Dash
- Up to 3 Axles
- LCD Display
- Single Trailer Only
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: Rear Suspension Support Recommendation for 2016 Volkswagen Touareg
- Q&A: Is Curt Venturer Trailer Brake Controller a Plug-and-Play Option on 2014 GMC Sierra?
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Recommended Brake Controller for 2003 Ford F-250
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Q&A: Best Brake Controller for an OEM Look on a 2021 Chevrolet Silverado 1500
- Q&A: Recommended Brake Controller And Wiring For 1995 Toyota T100 Pickup Truck
- Q&A: Availability Of 5 on 4-1/2" Hubs For A 3/4" Spindle
- Q&A: Does 12 Volt Accessory Circuit of Trailer 7-Way Wiring Have Fuse Protection
- Article: Printable Trailer Bolt Hole Pattern Template
- Article: Troubleshooting Brake Controller Installations