E-Track and Motorcycle Wheel Chock Recommendation for Securing Motorcycle to Trailer
Updated 01/26/2015 | Published 01/25/2015
Products Featured in This Question
Question:
I have a 7ft wide enclosed trailer with 3/4 plywood floor. I am mounting 3 wheel chocks across the 7ft width.I plan to run a 7ft piece of e track across the front of these wheel chocks same width of trailer . Do you for see any issues? Thank you.
asked by: Perry D
Helpful Expert Reply:
That sounds like a great plan, the E-Track part # E19148 will provide a great tie-down point for securing the motorcycles. For tie-down rings you would want the # 59131 and then for a wheel chock I would recommend the # 3481731 because of how well it secures motorcycle and how easy it is to use. Check out the review video I attached for more info.
Product Page this Question was Asked From
Erickson Horizontal E Track - Zinc Plated Steel - 2,000 lbs - 5' Long - Qty 1
- E Track
- E Track Rails
- Horizontal
- 5-1/8 Inch Wide
- 2000 lbs
- 5 Feet Long
- Erickson
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Are There Long-Term Service Contracts To Use PingMaster Trailer Tracking Devices?
- Q&A: How Many Additional Panels Can Be Added To The Rich Solar RV Solar Charging Kit RS37VR
- Q&A: Is E-track Stronger Than X-track, Is There An Advantage Of One Over The Other
- Article: How to Install E-Track in 3 Easy Steps
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Q&A: Mounting Suggestion For E-track To Aluminum Utility Trailer
- Q&A: Mounting E-Track for Hauling Motorcycle on 8 x 5 Trailer
- Q&A: Mounting Width Required for Thule AirScreen 52 Inch Fairing
- Q&A: Solution for Roof Fairing on Vehicle w Rail Grab Roof Rack Where Theres Gap Between Roof/Fairing
- Article: Printable Trailer Bolt Hole Pattern Template
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Hand Winches
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft
- Article: Trailer Wiring Diagrams