LED Tail Light to Replace a Peterson 421 Tail Light
Published 01/23/2015
Products Featured in This Question
Question:
Will these work? Swap out?
asked by: Ase
1
Helpful Expert Reply:
I checked with Optronics and the GLOLight Trailer Tail Light # STL111RB should have the same dimensions as the Peterson 421 light. It is 6-1/2 inches across and approximately 2-1/8 inches tall. Compare the measurements to your existing Peterson lights to confirm.
If the Peterson lights do not use a pigtail that plugs into the back of them then you will also need # A47PB.
expert reply by:
Michael H
1
Product Page this Question was Asked From
GloLight Halo LED Trailer Light - Brake, Tail, Turn - Submersible - Oval - Red
- Trailer Lights
- Tail Lights
- Brake/Tail/Turn
- Oval
- Recessed Mount
- Submersible Lights
- LED Light
- 6-7/16L x 2-5/16W Inch
- Red
- Optronics
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Comparing Kenda KR03, KR35, And KR53 Tires
- Q&A: Replacement Tail Lights and License Plate Light for a Triton PWC LTWC1 Trailer
- Q&A: Is There A Hitch Extender For 2.5" Hitch With A 7,500lb GTW Capacity
- Q&A: Replacement Brake Pads for Dexter 3,500 lb Trailer Axle
- Article: How to Bleed Your Trailer Surge Brakes
- Q&A: Replacement Composite Latch Handle for Demco eZ-Latch Trailer Couplers
- Q&A: Recommended Aluminum Oil Cap Cover to Replace a Dexter 21-88
- Article: The Definitive, Step-by-Step Flat Towing Setup Guide
- Q&A: What Info is Needed to Pick Out Cushioned Equalizers for Jayco Bunkhouse
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Article: Converting Your RV Water Heater to Tankless
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: Most Popular Wheel Bearings