Diameter of the Install Holes of the Ear Mount, Plastic Trailer License Plate Light # LP81BB
Published 01/16/2015
Question:
I have a question about LP81BB. What is the size fastener needed for this part to mount?
asked by: Jeremy
0
Expert Reply:
I went out into our warehouse and measured the install holes of the Ear Mount, Plastic Trailer License Plate Light # LP81BB and found them to be 3/16 of an inch in diameter.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Trailer License Plate Light with Housing and Mounting Bracket - Clear Lens - Black Base
- Trailer Lights
- License Plate Lights
- License Plate
- Rectangle
- Surface Mount
- Non-Submersible Lights
- Incandescent Light
- 4L x 1-9/16W Inch
- White
- Optronics
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: What Surge Brake Actuator do I Need for My A-60 with Drum Brakes in Fulton Fold Away Tongue?
- Q&A: Identifying 5th Wheel Frame Numbers
- Q&A: Dimensions and Warranty of the Pro Series Square Jack # PS1400950376
- Q&A: How to Replace Interior Ram Jack Rod and Nut # TJD-12000-RODNUT on 12000 Series Jacks
- Q&A: Replacement Dexter Brake Assemblies for 023-027-00 and 023-026-00
- Q&A: Lift Kit Needed for Lippert Torsion Axle
- Q&A: Axle Riser Kit for a Lippert 3500 Diamond Axle
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Lighting Requirements
- Article: How to Measure a Trailer Axle
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: Performance Chips and Modules