How to Replace Bulbs of the Truck and Trailer Identification 3-Light Bar with White Base # MC77RB
Published 12/16/2014
Products Featured in This Question
Question:
how do you replace the bulb ?
asked by: Jeff
0
Expert Reply:
Product Page this Question was Asked From
Identification Light Bar for Trucks and Trailers - Incandescent - White Steel Base - Red Lens
- Trailer Lights
- Clearance Lights
- Rear Clearance
- ID Bar
- Surface Mount
- Non-Submersible Lights
- Incandescent Light
- 16-3/4L x 1-3/8W Inch
- Red
- Optronics
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Do I Need to Remove the Identification Light Bar to Replace the Lights?
- Article: Trailer Wiring Diagrams
- Q&A: Replacement Lens for Trailer Taillight SAE AP2 99 DOT
- Q&A: 10k Dexter Replacement Hub for a 8-415
- Q&A: What Is The Shoe In A Schwintek Slide Out System And What Does It Do
- Q&A: Difference Between P225/70R15 and P225/75R15 Tire Sizes
- Q&A: Dimensions of the Brophy Stake Pocket Tie Down Anchors
- Q&A: Replacement 5-Wire Switch For a Lippert Slide-Out
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Most Popular Wheel Bearings
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Trailer Lighting Requirements
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Measure for Motorhome Steps