Roof Rack Includes:
Part Numbers: INXB130-2,INXS250,INK108
Low-profile, aerodynamic crossbars create an aftermarket roof rack for your vehicle. Aluminum bars have T-slots that let you mount channel-mounted carriers and accessories. Flexible rubber strips in T-slots keep out dirt and won't need trimming.
Features:
Specs:
These low-profile Inno Aero crossbars let you build a stylish, aerodynamic roof rack for your vehicle. The crossbars require 4 Inno Flush or Through feet to mount the rack to your roof. You may also need a custom fit kit to mount the crossbars. Built-in T-slots in the tops of the bars let you easily mount carriers and accessories on the rack. Flexible rubber strips in the channels keep out dirt and require no trimming or adjustment. The crossbars are also constructed of strong yet lightweight aluminum so they won't rust.
These lightweight bars have an elliptical shape. This aerodynamic, low-profile design helps to reduce wind noise and drag when you drive. This means you won't need to add a fairing.
Inno Aero crossbars are constructed of sturdy, lightweight aluminum. Internal extrusions add strength and structural rigidity without adding a significant amount of weight. The bars are rustproof so you can leave them on your roof all year long, wherever you go. The sand-blasted powder coat finish resists corrosion, scuffs, and scratches. And the matte black color will look good on any vehicle.
Each crossbar has a channel in the bottom that lets you install Inno feet (sold separately). Slide the channel cover over to reveal a mounting hole for the foot. Clip the foot into the crossbar and then slide it into place along the channel. Built-in bar end stops in the channels will keep the feet from sliding off the ends of the bars.
To complete installation, mount the feet to your roof. This may require a custom fit kit (depending on your application). Attach the locking covers (included with the feet) to secure the roof rack to your vehicle. Locking the covers also secures T-slot-mounted accessories to your crossbars.
This bar has a built-in T-slot that allows you to mount bike racks, watersport carriers, ski racks, and more. The EZ-Slide rubber strip in the bar lets you mount accessories without the need to remove or trim the strip. Just press down on the ends of the flexible strip and slide your accessory's mounting hardware into the T-slot. This strip has a plastic coating so it's easy to slide T-bolts along the channel. The strip runs the full length of the bar, so it helps keep dirt out of the channel when you're not carrying accessories.
You can also attach most clamp-on accessories to the bar, and the rubber strip provides a no-slip cushion for any accessories that rest on it.
These Through feet help you mount 2 Inno Aero crossbars to your vehicle's naked roof to create an extended-length roof rack. Locking covers secure system to roof.
Features:
Specs:
These custom-fit clamps and pads let you mount 4 Inno XS200, XS250, or INSU-K5 feet to your vehicle's naked roof to help create an aftermarket roof rack system. Clamps mount to feet with bolts. Kit includes 4 clamps and 4 pads.
Features:
Specs:
Average Customer Rating: 4.8 out of 5 stars (1094 Customer Reviews)
Low-profile, aerodynamic crossbars create an aftermarket roof rack for your vehicle. Aluminum bars have T-slots that let you mount channel-mounted carriers and accessories. Flexible rubber strips in T-slots keep out dirt and won't need trimming. These Through feet help you mount 2 Inno Aero crossbars to your vehicle's naked roof to create an extended-length roof rack. Locking covers secure system to roof. These custom-fit clamps and pads let you mount 4 Inno XS200, XS250, or INSU-K5 feet to your vehicle's naked roof to help create an aftermarket roof rack system. Clamps mount to feet with bolts. Kit includes 4 clamps and 4 pads.Very nice quality, made in Japan. Easy to install using the Inno XS150 base stays. The 51" was a nice size for my 2015 Touareg. Many of the manufacturers recomment wider (53-54"), but I like the narrower profile. Unfortunately, the Aero design still creates a slight bit of wind noise at highway speeds, and it gets worse if the sunroof is raised (vent). I like the soft rubber T-channel material which allows the accessories to mount without cutting the material. I also like the slightly arched shape.
We recently purchased 2 kayaks & Thule roof racks from our local outdoor store.
After waiting 2 weeks for our roof racks and J bars to come in we found that the Thule racks did not fit our 2017 Lincoln MKX and they didn't make any racks that would. The vehicle does not have roof racks and has a moon roof.
After a couple of days searching the internet we discovered etrailer.com. We found the Inno roof racks, but still was not sure they would work. We spoke to a repesenative and he assured us that the racks we chose would fit and the Thule J bars we did return would also work. As you can see by the photos 2 days later we were happy Kayakers.
I just received and instilled my rack system. Time will tell, but my initial reaction is that of disappointment with the quality of the system, considering what I spent. The cross bars seem to be plastic, and the end caps on the cross bars seem to be plastic and covered with a faux metal chrome. I am curious to see how well this system holds up to the hot Florida sun. The positive is that I like the general shape of the aero crossbars, and they are relatively quiet when I am driving.
I bought these as part of a kit with 60" Aero bars and the appropriate kit for my 14 Flex. I spent probably an hour and a half double checking my measurements and getting them torqued down properly. I spaced the bars on top of the car just a little wider than proscribed because I was planning on carrying 4x8 plywood, and it looked better to my eye. One thing to watch for: The instructions for the car-specific kit (in my case INK263) show the foot spacing measurements for a square bar, and the measuring point for these feet and Aero bars is different. That measurement point is indicated in the instructions for the feet, not the kit. Same numbers, just different reference point. Otherwise, they look good and are rock solid.
Has worked great for transporting my fishing Kayak as well as small loads of lumber. It has worked fine for about a dozen and a half boards at a time or a couple of sheets of plywood. Just make sure that you have a good way to strap them down as well as maybe a rubber mat to help hold everything in place. The noise from it on the high way can be a lot but certainly not as bad as some that I have heard. I figure that anything on the outside of a vehicle like that will produce some noise.
This kit does not fit well. All measurements have been double and triple checked down to the millimeter. The lock on the covers interfere with the hooks. You have to apply so much pressure to get it to close that it makes the rack come loose. Not very satisfied
Installation was a little tricky but once the "feet" were attached to the roof and the bars properly spaced, everything wrapped up very well.
There is no noticeable wind noise with these installed.
worked as expected, I used them to carry my hobie outback kayak (about 100lbs) on my Honda Civic 2016 Coupe (2 doors). They worked with no problem so far (1 year) even under high speed like 70mph.
Great racks. High quality parts. Fit perfectly. Went together easily.
One was extremely hard to get on compared to the others (not sure if it had some rough machining or something), but once all we’re on, all was good
Racks were perfect for my Acura MDX. They fit like a glove and I have used them several times.
I did a lot of searching before selecting this rack for my Durango RT (no factory roof rails). It is easy to reinstall once the initial process is followed, I marked my doorjambs with a sharpie and it is easy to set up. Great product!
Noticed box was taped up more then usual, found other manuals that was not specifically for this, and also found one of the feet already had been mounted as there was scratches on the plastic and metal parts
These work great! Perfect for mounting J-bars to carry our kayaks. We've already used them for over 30 trips with our kayaks, and they are still like new. e-trailer always provides expert help in making sure I am getting exactly what I need. I am a loyal repeat customer.
I upgraded to these Aero Crossbars hoping it would mean a quieter drive with less wind noise. I am so glad I did. There is not noise at all with these bars. I use them with my roof cargo carrier and I don't even notice it is there. These bars are even strong enough to haul my canoe. I am very pleased with them.
Started assembly last summer and finally completed installation this spring. Directions took a lot of attention to detail but were adequate. Rack went on car securely and looks great. Have attached kayak rack and a roof pod and both worked flawlessly. Would definitely recommend.
Once I realized which bar was the front one and which was the back it was a fairly easy install. Since the measurements for the foot placement were wrong in the instructions I would suggest not tightening the feet all the way to the bars until you put it on the car. It would have been nice if both sets of rubber pads were the same, with the tunnel hook, and if they had adhesive backing to avoid losing them. I added 2 sided tape.
etrailer was the only vendor who had the custom fit roof rack feet I needed for my vehicle. I was trying to put a roof rack onto a Dodge Durango SRT...not a typical vehicle for this accessory! I looked everywhere for a suitable roof rack and thought I was settling by ordering the Inno kit from etrailer. I could not have been more wrong! I am so happy with the purchase!
These fit the car along with the other Inno items perfectly. They are very secure when combined with the other Inno products. No worries of the rack system coming off. Using them to transport kayaks using kayak holders.
Worked fine after I had rails installed on my BMW X3. Said it would work without them but I tried and couldn’t get them to attach.
These feet are easy to use and go well wit the Inno system. I was worried since my car did not come with any roof racks, but this is the solution to haul things on my roof. They work well and are very secure.
thanks to Adam for help and competent approach. Adam listened impeccably and in the shortest possible time helped to deliver the goods I needed
These are made perfectly for your vehicle. They are very secure when combined with the other Inno products. No worries of the rack system coming off. Using them to transport kayaks using kayak holders.
Purchased with the, "Inno Through Feet for Aero Crossbars," for our 2017 Sienna. Pretty simple to install, maybe 20minutes after reading instructions. Seems solid.
Ask the Experts about this Roof Rack
Do you have a question about this Roof Rack?
Inno Accessories
Fit to this rack on your 2000 Toyota RAV4
Info for these parts were:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.