What our customers are saying:
Very broad selection and outstanding service.
Mike
Eagan, MN
Videos
for Vehicle Heaters
Help Articles
Expert Answers
Yes, the Kat's Heaters Ether Start Fluid Injection System #KH33210 would still work if you didn't hook into the thermostat and would spray ether on each startup instead of only when the temperature hits below 50 degrees.
For your 2018 Toyota RAV4 with the 2.5L I4 engine the Kat's Heaters Custom Fit Engine Block Heater #KH11813 will work perfectly. This cartridge heater will clip right into the cavity of your engine block and submerges in the coolant to keep…
You do not want to use a holding tank heater like ThermaHeat #277-000164 on a battery but we do offer battery heaters specifically intended to protect one from extreme cold. You can see all such items on the page I linked for you. You'll want…
According to manufacturer's application guide your 2018 Toyota RAV4 LE with a 2.5L 4-cylinder engine would need the Kat's Heaters Custom Fit Engine Block Heater #KH11813 and it would need to be installed in the 'RL'…
I checked with Kat's and the Kat's Heaters Custom Fit Engine Block Heater #KH11813 that fits your 2013 Lexus RX 350 will install in the left front position, as indicated in the cut out of the manual I attached. Kat's does…
I checked with Kat's and the correct Kat's Heaters Custom Fit Engine Block Heater for a 2019 Kia Sportage with 2.0 or 2.4 engine is part #KH11812.
Kat's does recommend coating the cartridge with NSCG silicone grease G-624 before inserting the cartridge heaters like the #KH11813 into the block.
I do have a potential solution for you. We do not recommend using the NOCO Genius charger and Jackery power bank combination. The battery bank will only last so long, and would require regular recharging. Also, it is not recommended to use a power…
For your 2016 GMC Canyon, the correct engine block heater will depend on which size engine you have. If you have the 2.5L I4 engine then you will want to use part #KH11484 but if you have the 3.6L V6 engine then you will want to use part #KH11811. If…
I checked with Kat's about the correct engine block heater for your 2012 Toyota Tacoma with a 2.7L I4 engine, I confirmed that the correct fit is the Kat's Heaters Custom Engine Block Heater #KH11481. According to Kat's, this will install…
Yes, you can absolutely drill holes in your trailer tongue to install the 10,000 lb capacity Buyers Products Straight Tongue Trailer Coupler #3370091560. This is a pretty common occurrence due to the various bolt hole patterns of straight tongue…
The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…