2013 Nissan Titan Grille Guard

The length of wire desired depends on your vehicle connection and your personal preference. You want enough slack for turning, but not so much for dragging as you mentioned. A little extra slack…

I agree, the bag for the NOCO Boost X Jump Starter #NOC88VR is a nice way to keep everything together but it definitely lacks in the protective department. To keep your Boost X Jump Starter safer…

Pace Edwards has two confirmed fitting Switchblade covers for your 2024 Chevy Silverado 3500 DRW…

There is a trailer hitch receiver as well as a 4-way wiring harness that fit your 2022 Jeep Grand Cherokee WL; that said, we…

The hub/drum you sent in a picture of is a Lippert 8,000 lb axle hub with an 8 on 6-1/2 inch bolt pattern designed for oil-bath applications. The correct replacement then is the #8-285-10UC3-A.

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on…

The Replacement Hardware Kit #AABRKT-5056 will fit the Aries Pro Series Grille Guard #AAP5056. This is the upgraded version of the Grille Guard #AA5056 which uses the same install hardware to attach to a truck.

We do have replacement mounting hardware for the Aries Grille Guard on your 2008 Toyota 4Runner. If you have the #AA2058 the correct brackets and hardware are the #AABRKT-2058. If you have the #AA66XB then you need the #AABRKT-2066.

I have the answer you are looking for. From your part number provided, you are talking about the Pace Edwards Switchblade Retractable Hard Tonneau Cover. Unfortunately, the #311-SWC95A17 does not fit your 2022 Chevy Silverado 3500. However, we do…

90-120 ft lbs of torque is probably about right for your trailer rims. If you check out the lug nut torque chart that I attached you will see that nearly all of the torque specs are that and higher.

Hey Jerry, the install of the Aries Bull Bar part #AAB35-4015 do require you to permanently remove the tow hooks to install. It looks like the similar Westin Ultimate Bull Bar part #32-3645 does allow you to keep them though.