2022 Jeep Wrangler 4xe Fender Flares

The Rackem Fitz-All Enclosed Trailer Ladder Rack #RA-28 does adjust horizontally to allow it to fit trailer roofs from 4-feet to 8-1/2-feet wide but its height is fixed based on the position of the roof rain gutters, which are required in order to…

The Rack' Em Ladder Rack part #RA-28 that you referenced is rated for 400 lbs when used within it's length range of 4 foot to 8-1/2 foot. You'd be totally fine at 8-1/2 feet to use it's full 400 lb capacity as it was rated and tested…

Yes, the Kenda Karrier S-Trail ST145/R12 Radial Trailer Tire #AM10140 referenced in your question will fit the same 12 inch wheel with a 4 inch width that your existing 4.80-12 size tires are mounted to. Just note that the ST145/R12 tire will be…

We do carry a variety of different trim and edging. Unfortunately we do not have a way to look up a model of trailer to know exactly what kind of trim you will need. We would want to try to match the current trim as best we can. A very common roof…

The lights you referenced in the photo for the Aries Front Fender Flares #AA1500201 wouldn't be factory lights. There is a similar product available for your 2012 Jeep Wrangler Unlimited that work with the aforementioned Fender Flares. The Aries…

We have what you need. I will list them below for you. The Blue Ox Aftermarket Off-Road Bumper Adapter - 7/8" Pin #BX88357 for your 1 inch D-rings. The etrailer SD Non-Binding Tow Bar for Blue Ox Base Plates - RV Mount - 2" Hitch - 6,000…

For a bumper mounted spare carrier that has capacity for an 80 lb setup we have the part #BR56VR from Brophy that fits a 4 inch bumper like you have and would work well.

Demco has a base plate kit that fits your 2016 Jeep Rubicon Hard Rock with the part #DM56GV which is correct fit with the Demco Commander II part #DM9511012 you have as well.

Using a hitch extender is safe as long as you stay within the limits specified of 50 percent of the hitch and vehicle load capacity, and 350 lb tongue weight capacity of part #HE06. The other option to provide additional clearance from your spare…

Yes, it does. The arm on the Kuat Pivot 2 Swing Away Hitch Extender item #PVD20B locks at 90 degrees and opens up to 120 degrees. I have attached a photo below that shows how this function works.

The center of the hitch pin hole for the Draw-Tite Max-Frame Trailer Hitch Receiver #DT37GR is 6" further out than the center of the hitch pin hole for the Curt Trailer Hitch Receiver #C76WR. Since the hitch pin hole determines where your…

For your 2022 Jeep Wrangler, the twist locks (the base plate tabs) will indeed connect to the end of the arms on the etrailer SD Non-Binding Tow Bar #e34ZR. You'll connect that directly to the Invisible Base Plate Kit #e98948. It's somewhat…