2012 Jeep Wrangler Unlimited Fender Flares

We do carry a variety of different trim and edging. Unfortunately we do not have a way to look up a model of trailer to know exactly what kind of trim you will need. We would want to try to match the current trim as best we can. A very common roof…

The lights you referenced in the photo for the Aries Front Fender Flares #AA1500201 wouldn't be factory lights. There is a similar product available for your 2012 Jeep Wrangler Unlimited that work with the aforementioned Fender Flares. The Aries…

Demco has a base plate kit that fits your 2016 Jeep Rubicon Hard Rock with the part #DM56GV which is correct fit with the Demco Commander II part #DM9511012 you have as well.

For your 2022 Jeep Wrangler, the twist locks (the base plate tabs) will indeed connect to the end of the arms on the etrailer SD Non-Binding Tow Bar #e34ZR. You'll connect that directly to the Invisible Base Plate Kit #e98948. It's somewhat…

Based on the measurements you have provided it sounds like you have pretty standard wheel studs. Kodiak stud #K12WB2 is nearly spot-on as far as the measurements. I have included a picture showing its measurements for you.

Whether or not you can flat tow with a Jeep bumper is really up to the manufacturers testing; some of the big names like MetalCloak or Poison Spyder have bumpers with D-ring attachments that can be used for flat towing connections. This is great…

On the Jeep Wrangler and Jeep Truck models the steering wheel does not actually lock with the ignition in the off position, it just has a loss of power steering-which is likely what you're experiencing. Jeep removed the steering wheel lock from…

The Air Lift LoadLifter 7500 XL part #AL57289 is a fit for your 2017 Ram 2500 Power Wagon. I attached an install video for this on a similar 2018 Ram 2500 for you to check out as well.

The articulink rear suspension on your 2017 Ram 2500 Power Wagon will not cause any issues with a set of airbags or a 5th wheel hitch because they all install in slightly different locations on the vehicle and do not counteract one another. For a set…

Great question. As a general rule, when your trailer is loaded to it's full capacity, there should be a minimum clearance of 3 inches between the top of your tire and the underside of your fender.This should give you adequate clearance for…

The minimum distance between the inside of a tire and the frame rail depends a lot on the setup of the trailer. But as long as the tire and the frame don't touch you would be fine. It's hard to give an exact figure as trailer setups can vary…

The 205/75-15 Tire and Wheel Combo, #AM32395, is 8.1 inches wide and 27.3 inches tall. An F78-14 tire and wheel will be about the same width but it will be 1 inch shorter. I have included a link to a tire size FAQ article that should help.