2021 Jeep Wrangler 3.6L V6 Engine Exhaust

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

Hello Dan, thanks for reaching out. The Firestone #F2550 for the 1999 Ford F-250 2WD will be compatible with the B&W Turnoverball gooseneck hitch. The brackets are designed specifically to be compatible with in-bed hitches like the B&W, so if…

Hello Phillip, thanks for reaching out. Yes, the Reese Dual Cam #RP26002 WD system can be used with a Reese Friction Sway Control #83660. As long as the head of your WD hitch has the pre-welded tab for the sway control ball (pictured below), the…

The inner diameter of the expanded ends of the part #CAM44812 is 1.53 inches and the outer diameter of the non expanded end is 1.51 inches. So basically this setup is designed to either slip into a 1-1/2 inch pipe or slip over a 1-1/2 inch pipe.

I have attached a drawing from the installation instructions for the rail kit part #C16430-204 you can check out. As you can see in the attached drawing I noted the carriage bolts and where they are located on the rails when installing. Please note…

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

For your generator exhaust, the Camco Gen-Turi Replacement 30" EMT 90-Degree Discharge Pipe #CAM44812 is designed to be used with the Camco Gen-Turi RV Generator Exhaust System #CAM44461. With that being said, we have not tested the #CAM44812…

If you already have the B&W Gooseneck Hitch #BWGNRK1111 on your 2015 Ford F-250 then you will need to get a different hitch as that one is not compatible with a 2017 F-250. For your 2017 Ford F-250 you will need to use B&W Gooseneck Hitch…

Hey Jay, thanks for reaching out! Our transmission coolers are designed to help support a factory cooler as opposed to replacing it altogether, so you won't want to replace it. With that being said, I have a few different options you can look…

Hey Jeff, There are Advent Air kits with just the rooftop unit or the whole setup with the air distribution box included. We've recently run into some compatibility issues with certain Dometic models so I do not recommend using any Advent Air…

I have attached a photo of the EcoHitch Hidden 2 Inch Trailer Hitch Receiver installed on a 2012 Ford Focus Electric. The hitch is designed to fit 2012 through 2014 Ford Focus Electric vehicles. If you're in the market for a bike rack, the…