2005 Dodge Ram Pickup 1500 - SRT-10 - 8.3L V10 Engine Exhaust

Hi Bruce, To lift your trailer we'll first need to check of the suspension and see if you have torsion axles or a leaf spring suspension. If you have torsion axles then I'll need to see…

You have a good eye as the black tubing sections are plastic for the Camco Gen-Turi RV Generator Exhaust System #CAM44461. It's just the curved pipe section that is made out of stainless steel.

Hey Michael, thanks for reaching out! The Timbren Active Off-Road Bumpstops #T28GR you installed on your 2018 Ford F-150 unfortunately have that reputation among users (although Timbren claims their systems provide a smooth ride). Because of this…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

I checked with Thule and the hardware is available to install the Replacement Fairing Clamp for Thule Canyon Roof Baskets #1500052562. What you need is Carriage Bolt #915-0622-54; if you also need the 3-Wing Hand Knob that is part #753-0783.

Because the face of the magnet rides against the armature (inside) surface of the brake drum, any grooves that had previously been worn into the armature surface will cause the magnet to wear unevenly. For optimal braking performance, you want…

I recommend going with the Air Lift LoadLifter 7500 XL Ultimate Air Helper Springs #AL89DQ for hauling around an in-bed camper with your 2024 Ford F-350 Super Duty. I really like this kit because it has the higher 7,500 lb rating (which you…

The air bag kit I recommend using for your 2022 Ram 3500 Cab and Chassis Dually is the Ride-Rite from Firestone: - Firestone Ride-Rite Air Helper Springs #F2478 I really like this kit because the air bags have the best construction on the market…

We have the following Gen-Y shock absorbing 5th wheel pin boxes which are compatible with the Lippert Rhino pin box bolt pattern. The weights listed below are the maximum capacities the pin box is capable of supporting. 21,000 lbs - 3.5K TW #GY86GR…

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being…

That sounds right to me Travis, but while you have everything pulled out it wouldn't hurt to re-measure and double-check. The height shouldn't have changed and everything should essentially go…

The tank that comes with the Air Lift WirelessAIR Suspension System for Air Helper Springs #AL27DQ is a 2-Gallon tank. When it comes to the physical dimensions, the tank measures 17" Long x 8"…