Traction Boards - Blue

Hey Dave, thanks for the pictures! Based on what you have and what you are looking for the Tie Down Spare Tire Mount part #TD66FR that you referenced would be a great option. This is very similar to what you have now so it would do a great job.

Hey Derek, thanks for the picture! The SeaSucker Universal Recovery Board Mount - Vacuum Mount item #SEA39XR is going to work great on your setup. These will have no problem attaching to the aluminum sides. It's not going to delaminate the…

I recommend the etrailer.com Trailer Hitch Receiver part #e98853 for the 2020 Toyota Sienna because of it's concealed cross tube design. The only portion of the hitch that is visible once installed is the receiver square which sticks through the…

I can absolutely help with choosing a trailer hitch for your 2020 Toyota Sienna that will give you the best ground clearance. There are quite a few hitch options available for your vehicle, but the models that will sit highest off the ground when…

The only bolt-on swivel jack we have that works with 6" tall trailer frames is the Trailer Valet 5X Swivel Jack and Trailer Mover part #STC-V211. The Trailer Valet has a 500 lb tongue weight capacity and works with frame rails up to 2-3/4"…

Hey Phil! For a tandem axle trailer you will want two of the Leveling Kit with Wheel Chocks for Trailers and RVs #WS28ER. You are correct, one under each tire is best. I use these on my Jayco with one under each tire to keep them off the ground and…

Yes, it does matter. If you put a load on the opposite side of the Brophy Stop Plate for E Track item #ETHSB it will bend.

First we need to find out if the problem is your tow vehicle wiring or your trailer wiring. To do this use a circuit tester like part #PTW2993 to test all of the pins on your 7-way for the correct function compared to the diagram I attached. Next use…

We have just the thing. The etrailer threaded hitch lock #e99047 uses a M16-2 bolt. This has a pin diameter of 5/8" with a 2-5/8" span.

You'll need to remove the ring terminal screws that hold the white wires of the #8880162 to the trailer but then the other connections simply plug into the female matching end on the trailer since it uses bullet connectors.

The Buyers Products 24" Fluorescent Orange Marker Kit #3371308103 are a hollow Nylon construction. They are pretty rigid/sturdy and are designed to be used on vehicles.

You could for sure. You would however want to make sure that the fender is reinforced enough to support the Markers #3371308103 so that they don't just rip the metal or plastic of the fender. I'd get some flat metal from a local home…