Good question! The etrailer trailer tool box #e44VV is made over seas, but I do have a couple made in America options listed below. They are fairly similar and I think they might be of interest to you, since the name you entered is Usaforme. DeeZee…
Hey Tracy, thanks for reaching out! For an Anderson connector that can be hooked up to the battery on your 2022 Frontier, I recommend picking up the Bulldog Winch Rear Wiring Kit #BDW20026 which comes with 24' of 3 Gauge wire and 2 Anderson-type…
Thanks for the photo and the Timbren Rear Suspension Enhancement System #TGMRCK15S you mentioned is a good option for helping keep your 2020 Chevy Silverado 1500 level, but the best option is something a little different, the RoadActive Suspension…
You will need to connect to the tow vehicle battery in this case. The issue with trying to install and run the RedArc In-Vehicle BCDC #331-BCDC1225D via the 7 way is that the 10 gauge wiring in a 7 way trailer connector isn't sufficient to…
Due to the lower tongue weight capacities of trailer hitches that have 1-1/4 inch receivers, there are no dual hitch adapters available for a 1-1/4 inch trailer hitch receivers. The adapters are only available for 2 inch trailer hitch receivers. If…
Hello Connie. The bottom straps of the WeatherTech Mesh Safety Barrier for Pets #WT96UQ go around the inner leg of the driver seat frame. Same thing for the passenger side. I have included a few snips from the instructions that you may find helpful.…
The Rhino-Rack XTray Pro Cargo Basket part #RRRMCB03 will work just fine with a set of crossbars like the Rhino-Rack Vortex Aero Crossbars. That said, I can only recommend using the universal wrap around mounts that come with the basket. It does not…
Thanks for providing that information it really makes this simple. To find the right Gen-Y we need to calculate your tongue weight using the formula GVWR x 0.22 = TW. The Z2900 has a GVWR of 14,495 lbs so the TW is 3,189 lbs. Based on this…
I went to the warehouse and took some measurements of the Camco Hitch-Mounted Flagpole Holder, part #CAM51611. I have attached a photo of the CAM51611 with the dimensions noted. With the distance of 15-1/4 inches from the center of the hitch pin hole…
The Redarc In-Vehicle BCDC Charger #331-BCDC1225D you were looking at requires a 40 amp fuse between the charger and the start battery, a 40 amp fuse between the auxiliary battery and the charger, and another 40 amp fuse between the auxiliary battery…
I checked with Valterra just now and they confirmed that all of the Valterra High Flow Water Regulator #A01-1114VP that you referenced is stainless steel including the spring so it will be basically corrosion resistant.
It sounds like you need Valterra Gray Water Drain Connector - 90-Degree - 1-1/2" FPT to 3/4" MPT Item #T01-0091VP. Or possibly Valterra 90-Degree Drain Elbow - 1-1/2" Female Swivel x 3/4" Barb Item #RF890. Or Valterra 90-Degree…
In these days of customer "no service" I am usually disapointed when doing business with people I don't know. It was refreshing doing business with you. I'm impressed!
Filters
