Covers - Round Pit

Hey Sherri, thanks for all of the info from your RV door! Knowing all that yes the MORryde step part #MR48RR that you referenced would be the correct fit and will work great as a set of stairs to get in and out of your RV. What camper do you have?

The HammerBlow Trailer Coupler, like the #BD028463 is a coupler that will mount to the from frame of a trailer and be used to attach to a hitch ball on the back of a vehicle. It mounts to 50 degree A-Frame Tongue and will couple to a 2-5/16 in hitch…

Hey Michael! Since you were looking at the SoftStartRV Soft Start #SSR54FR are you wanting that built in as well? The Active Controls ActiveStart Plug-In Soft Start for RVs #AS94FR is a soft start and surge protector all in one. If you aren't…

For your utility trailer, there aren't specific covers made, however you can use a travel trailer cover for your application. I recommend the Adco Olefin HD RV Cover for Travel Trailers up to 18' - All Climate + Wind - Gray #AD37ZR or the…

I drew up a diagram below that displays the dimensions from the center of the mounting points to the center of the crosstube so that you can measure and determine if the Curt Custom Base Plate Kit #C68FR would clear the bumper. In the attached video…

The Adco SFS AquaShed Cover for Bumper Pull Trailer part #290-46004 would be an excellent option for a 7 x 14 V-Nose Enclosed Trailer. The Adco SFS AquaShed Cover for Bumper Pull Trailers is actually designed for horse trailers but it will work well…

For your 7' x 16' V-Nose enclosed trailer I recommend the Adco SFS AquaShed Cover for Bumper Pull Trailer #290-46005. This is designed for trailers up to 18' long so you'll have a little bit of extra material for an easier fit. There…

Good question! Can you close the hatch of the vehicle the CVT Timber Creek Annex #RG35ZV is attached to? Yes. However, it should be noted that the hatch is actually acting as a roof support, so some of the roof will not necessarily cave in, but it…

The Mount-n-Lock GennyGo Generator and Cargo Carrier MNT34FR is meant to be mounted on the bumper of your RV and cannot be mounted to the tongue of your trailer without some pretty extreme modification and fabrication. However there is still a…

For your Stromberg Carlson Trailer Tray Cargo Carrier for A-Frame Trailers #CC-255, we have the Storage Cover for etrailer 4,500-Watt Generator #333-0010, which will fit generators measuring up to 18-7/8" long x 15-3/8" tall x 11-3/4"…

I tried it to make sure, and the t-bolt #853-0782 will fit inside the groove on the top of the Thule AeroBlade bars. The knob #753-0776 will also fit on the bolt. I have attached some pictures of the bolt in the groove with the knob on the bolt for…

It looks like you have the Thule Aeroblade bar. The T-slot dimensions are 1/2 inch wide for the top of the opening and 3/4 inch wide at the bottom. The T-slot is 1/8" inch tall.