1990 Eagle Premier Catalytic Converters

Hey Matt, congratulations on the new truck! For the TS rails that come with that tonneau cover we have the Yakima OverHaul HD Adjustable Truck Bed Ladder Rack. Most people get the version with 68" crossbars #Y01151-5855 but if you want 78"…

You would need one of two part numbers to replace the wheel studs in the Complete E-Z Lube Hub & Drum Assembly, item #8-201-5UC3-EZ. If your existing drive in studs are 1-13/16 inches long (measurement B on the product page) you will need the…

We've got you covered! To replace your wheel bolts you need the Dexter Wheel Bolt #7-262 which is a 1/2" diameter and 2-11/16" long. Since your hub and drum assembly looks to be pretty worn though I recommend just replacing the whole…

For your 1996 Chrysler Intrepid we have the Drivers Side Front #MF50205 and Passenger Side Front #MF50204 direct fit catalytic converters. These will fit both the 3.3L and 3.5L engines. We do also have the Rear Converter #MF23286 for the 3.3L and the…

The Dexter 8-427 hub is no longer available. Even looking through Dexter's site the only references to it are replacement bearings. You can use a wheel with a larger pilot hole as long as the wheel attaches to the hub using lug nuts and not…

Generally speaking no, the direction of exhaust gases does not matter when passing through a catalytic converter like the MagnaFlow Stainless Steel Catalytic Converter part #MF23882. If the direction of flow does matter then it will be stamped onto…

Hey Nate. All the connectors are going to seal up about the same and have identical issues. What you need to do is use Dielectric Grease item #11755. It covers your contact points and keeps moisture away. It also helps with conduction. To add a hitch…

Hello Blake, thanks for reaching out. I did some digging and I was able to find a reference for the 92655 hub. This uses the 15123 inner bearing and 25580 outer bearing. It will be a 12" drum as well. This reference didn't tell me the bolt…

California's emission control standards are stricter than most states. This is why many auto parts, like the MagnaFlow #MF93257, are not approved in California but are in other states. It's referred to as CARB certification because of the…

Hey Steve, great question but just changing the wheels and tire will will not affect the fit of the air bag kit and compressor you plan to install on your 2024 Ram 2500. The only thing that does change things is if you were to install a lift kit…

Yes, you can use Curt trailer wiring harness #C56197 on your 2015 Chevy Camaro with incandescent lights and trailer with LED lights. I have included a link to the installation instructions for you.

To manually retract your slide-out you'll need to use a 5/8" socket on your Gear Motor Assembly for Lippert Electric Slide-Out #LC386327.