2006 Toyota Matrix Bug Shield

The Leer Soft Tonneau Cover #LE38VR is a great option for your 2024 GMC Sierra 2500 with the 6-3/4' bed, but since you're wanting to use a ladder rack as well we need to look at a different solution as the clamping system and…

The manual switch for the Pace Edwards Bedlocker Retractable Hard Tonneau Cover #PE44CV can be found as part #311-BL-1120 on our site. This plugs into the harness at the canister and then you route and install the switch wherever it works best for…

Hey Bill, yes the Draw Tite hitch part #DT65GR does come with all of the needed install hardware for the hitch including the fishwire bolt leaders.

We've checked in the past and have been told the only current landing gear motor that can be used with your Atwood setup is the part #LG-142178 which even having a lower capacity will still do a great job. The jack motor…

Currently SuperSprings only offers the rear SuperCoils for your 2019 Ram 1500 2wd. They are available in either a 2,058lb #SSC-50 or 2,480lb #SSC-51 coil capacity. If you plan on keeping the camper on your Ram then go with the higher capacity…

In order to figure out if your 2019 GMC Terrain has the factory tow package or not, you'll need to take a look in the rear fuse box on the driver side of your vehicle. In the fuse box there will be two locations you'll need to check -…

We do have a trailer hitch receiver that fits your 2024 Nissan Pathfinder, from Curt. The correct part number is the following: - Curt Trailer Hitch Receiver #C46DR

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

Thanks for all of the details, Peter! I'll answer your questions about the 79" Inno Square Crossbars #IN436L and Yakima Replacement Locking Knob #8890239 in the order that you asked them just to make it easier to keep track of: 1.…

Since you said you couldn't find a power level option on the Edge programmer you have on your 2008 Ford F-250 there is a great chance you actually have an Insight Monitor like part #EP84030. This product only allows you to look at various…

When installed on your 2000 Ford F-250 7.3L Diesel Engine, the Edge Evolution CTS3 Performance Tuner #EP96TR that you referenced will give you up to 120 horse power and 315 ft lbs of torque. This tuner will plug right into the truck's OBD-II…

The Edge Diesel Evolution CTS3 Performance Tuner #EP96TR referenced in your question is confirmed to fit your 2002 Ford F-250 7.3L Diesel. I can't be certain what your local shop is referring to with regards to an existing chip on your truck…