2000 Chevrolet Malibu Bug Shield

For the Edge CS2 Evolution Diesel Tuner you will need to enter the programming menu. You will turn on your vehicle without starting it. Then use the Menu button to open the main menu and scroll down with the arrow to the Programming on the screen.…

The manual switch for the Pace Edwards Bedlocker Retractable Hard Tonneau Cover #PE44CV can be found as part #311-BL-1120 on our site. This plugs into the harness at the canister and then you route and install the switch wherever it works best for…

Thanks for all of the details, Peter! I'll answer your questions about the 79" Inno Square Crossbars #IN436L and Yakima Replacement Locking Knob #8890239 in the order that you asked them just to make it easier to keep track of: 1. Yes, the…

We've checked in the past and have been told the only current landing gear motor that can be used with your Atwood setup is the part #LG-142178 which even having a lower capacity will still do a great job. The jack motor doesn't support the…

Currently SuperSprings only offers the rear SuperCoils for your 2019 Ram 1500 2wd. They are available in either a 2,058lb #SSC-50 or 2,480lb #SSC-51 coil capacity. If you plan on keeping the camper on your Ram then go with the higher capacity…

In order to figure out if your 2019 GMC Terrain has the factory tow package or not, you'll need to take a look in the rear fuse box on the driver side of your vehicle. In the fuse box there will be two locations you'll need to check - K2 and…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

We do have a trailer hitch receiver that fits your 2024 Nissan Pathfinder, from Curt. The correct part number is the following: - Curt Trailer Hitch Receiver #C46DR

The Edge Diesel Evolution CTS3 Performance Tuner #EP96TR referenced in your question is confirmed to fit your 2002 Ford F-250 7.3L Diesel. I can't be certain what your local shop is referring to with regards to an existing chip on your truck but…

When installed on your 2000 Ford F-250 7.3L Diesel Engine, the Edge Evolution CTS3 Performance Tuner #EP96TR that you referenced will give you up to 120 horse power and 315 ft lbs of torque. This tuner will plug right into the truck's OBD-II port…

That means the programmer you have was installed on a different vehicle and wasn't returned back to stock before you got it. These can only be programmed to one vehicle at a time, so you'd have to track down the original vehicle the…

I checked with Edge and they do make a custom mount for the Edge Diesel Evolution CTS3 Performance Tuner part #EP96TR and your 2008 Ford F-250, the Custom Dash Pod for Edge Monitors that has a CTS3 adapter is the part #EP28500. However, this is a…