# 1
Furrion Vision S Wireless RV Backup Camera System w/ Night Vision - Rear Mount - 7" Screen
Haven’t had long but I really like it, bought this to go on my enclosed trailer because I go into areas that I need to turn around which requires backing up and some are really tight and the way I turn I can’t see what is behind me, this helps alot
This is not an eTrailer issue, this is a Furrion issue, it works, but it has a very weak connection on my 42’ trailer and loses connection repeatedly. May make a difference if I had the side marker cameras, time will tell. I have to get them first. But, something is better than nothing when backing.
# 2
Furrion Vision S Wireless RV Observation Camera System w/ Side Marker Light Cameras - 7" Screen
Have not been out on the road yet but the install was easy even for a novice like me. My reflection 5th wheel was prewired so it was a plug and play for the rear camera. For the side cameras I used the two screws from the previous light. I put both screws in the top holes, (one behind the camera) as that seemed to secure it better then bothe screws not behind the camera. Instructions were a bit limited(or I didn't read them) on the side camera sync but I pressed enough buttons to figure it out. Picture looks great. Do watch for obstructions such as awning supports which will limit view. I also used silicone to keep the water out.
The installation was fairly easy. The trailer came prepped for the rear camera so, it was attached and linked. The side cameras involved a little work due to being close to the pass-through doors. They went on with a bit of cutting of the trailer skin. The problem is the right side trailer camera is reading that it's the left side and visa versa for the right. They are both installed correctly, facing back and the pairing button on the bottom. Also when the two side cameras paired they caused the rear camera to unpair. I re-paired the rear and now the right side ( left camera ) is unpaired. I've emailed Furrion for answers to my situation.
# 3
Furrion Vision S Wireless RV Backup Camera System w/ Night Vision - Rear Mount - 4.3" Screen
My trailer was prewired for the Furrion camera so it was truly a plug and play install. Haven’t used it yet but everything works as it should.
I want to love this, but frankly I have consistent video dropout and lag issues towing a 26-foot GD Imagine trailer in various weather conditions. I tried fully disconnecting and resetting, repositioning antennas, and praying to the antenna gods, but it's only good for about two-thirds of the time. I think "YES, finally!" and then it starts dropping out again, making me insane. Also, as far as I can tell, there is no real good antenna upgrade for this. I suspect if you have a shorter trailer, or some fancy way to beef up the signal you'll do better.
# 4
Furrion Vision S Wireless RV Backup Camera System w/ Night Vision - Rear Mount - 5" Screen
After one year of use with the Furrion Camera I am completely convinced it is the best add on we have put on our camper. It is really useful driving down the road. Also, good for seeing how close you are to an object when backing in.
etrailer is a great resource. This camera was a breeze to install on my Grand Design which was pre wired for this product. Camera includes sound which is a value add. One note, the camera wiring from Grand Design to the camera mount is only hot when the tow vehicle is connected AND the running or headlamps are on.
# 5
Furrion Vision S Wireless RV Backup Camera System w/ 3 LED Marker Light Cameras - 7" Screen
Have not tested this on the road, so this covers installation. Instructions are clear and easy to follow, I was not clear about what to do with the trigger wire when you are retro fitting to an older RV, the FAQ on etrailer had the info, thanks for that. Installed this on a 2000 Lance camper sitting on a 1978 Ford F250 The side cameras were very easy to install, the backup camera required a little bit on modification to the camper. I did not like the monitor install options so did some simple modifications to the stand so I could use ram-mounts. Final setup is amazing
It was plug and play as advertised
# 6
Voyager WiSight 2.0 Wireless Backup Camera System w/ Night Vision for Prewired RVs - 7" Screen
My RV came prewired for this system. I had my RV for two years before I got this camera. It’s not just a backup camera … it’s a rear view camera! I feel so much safer on the road being able to see behind me. My only suggestion would be a protective sleeve for screen when not in use and storage pouch for mount and wiring.
System really works for us. The screen came paired with the camera. Camera was super easy to install. The larger screen makes a HUGE difference, the 5" screen was ok, but the 7" really makes it a lot easier to see what's coming up behind me when on the road... really helps!! spend the little bit extra to go 7" over 5"!! For prospective buyers... make sure you know what connection is on the back of your trailer if it has a built in connection... the salesman told us it was a different brand... oops. Fortunately etrailer gave me full credit for the return on that and sent out this camera and screen... once again, etrailer showing their high level of customer service.
# 7
Voyager WiSight 2.0 Wireless RV Backup Camera System w/ Night Vision - Rear Mount - 7" Screen
Replacement for a first generation system that came with our 2016 Airstream camper. Camera identical but screen is larger, much improved and more customizable. Works great for driving/towing and tight backup situations. Questions and advice I received from etrailer.com before purchase very helpful and best price I could find online.
This is a Great product and a Great value. I could have used my old wire but decided to try wireless and the range is excellent. The rear view is excellent. I was able to set the angle to see my trailer hitch receiver and see over what I am towing behind the motorhome. I used a 3x8x1/8-inch aluminum plate (purchased elsewhere) to mount this camera.
# 8
Voyager WiSight 2.0 Wireless RV Backup Camera System w/ Night Vision - Rear Mount - 4.3" Screen
I installed this on my Airstream Bambi just above the license plate. Removed license plate light to expose light power wires. Drilled a large hole to fit the rubber grommet using a step drill, then drilled two small mounting screw holes using bracket as hole drill template. Fed the assembled camera connector through the large hole and pulled the camera connector wires out the license plate light wire hole. Solder camera connector wires to license plate light wires (confirm polarity) and stuffed all wires back into hole. Installed grommet and camera bracket sandwiching the grommet between the back of the camera bracket and trailer siding for a water proof seal. Camera paired first try. Be sure to power only the monitor on first, wait for screen prompt, then turn on camera using trailer lights. Camera image is crystal clear and I've not noticed any image lag. It's been great so far.
Mounted camera on rear of my 1983 Avion travel trailer. Other cameras are made to mount on a flat surface. Since my camper has rounded corners, this was the only camera that would mount correctly.. Wired it into my marker, lights and picks up the signal well from the back of my trailer to the cab of my truck is approximately 45 feet. As always, super fast shipping from Etrailer.
# 9
Voyager WiSight 2.0 Wireless Backup Camera System w Night Vision for Prewired RVs - 4.3" Screen
This camera sucks! The instructions that came with the product didn't even match how to actually install the product. I watched youtube videos, but those didn't fit how to connect the camera in the vehicle. Then I had to call Voyager and talk to them about how to install it. It is the most stupid install and very cumbersome. The camera installs in the vehicle like it was built in the 1990s. It's awful, but I'm stuck with it because 2023 Winnebago pre-wired its travel trailers to work with this brand. Avoid buying this camera, unless you absolutely have to.
It was a snap installing this camera. Easy to navigate and understand through the screen. My travel trailer came with the pre-install plug. That made it extremely easy. To install. I am still trying to navigate to where I want to put the monitor. But all in all, it's a great tool to have in assisting in backing up.
# 10
Buyers Products RV Backup Camera System w/ Night Vision - Rear Mount - 7" Screen
We purchased this camera to help get our rv in and out of a tight storage spot and to see behind the trailer while driving. The tow vehicle is much narrower than the trailer making it impossible to see behind the trailer even with extended side mirrors. This system allowed me to avoid cutting off any vehicles approaching from behind when changing lanes. The display was installed on top of the dash. The camera replaced the built in furion mount on the trailer. Due to short time, the cord was run externally. This kit is meant for a motorized rv, not a trailer. After opening the kit I realized I had to buy an extension cord to run from the display adapter cable to the rear of the tow vehicle. Then the cable could be disconnected at the trailer hitch. When using the system, the display is good, but very narrow field of view, vertically. So I can either see traffic or see the rear of the trailer for backing up. A second camera would seem to be the best solution but not my favorite one. The mic and audio did not work well. I could not hear my wife, but hilariously, I could hear cars at the rear. Might just be me ... I only ever used channel 2 which I thought was the only channel carrying audio. HINT: adjusting the volume was extremely painful until my wife figured out to adjust it on another unused channel. The brightness could not be adjusted making it bright at night. I aimed the display downwards to help. The instructions seem sufficient and are very brief. The system operates like a prototype rather than a finished model. But it does show the camera even with the display on the dash in the hot sun. We used it for the entire 3300 mile trip. It was on the entire time we were driving. I removed the display after returning home with my fingers, no tools. Overall, I am ok with the system. I still think it was the best purchase for me considering the cost of other systems and the wireless connection problems of other systems except perhaps for the most expensive. Note, I read someplace that some states may not allow a display to be on where the driver can see it while driving.
Ez to install—plug and play. Complete wired system—much more dependable than wireless and a lot less fussy to use. I cable tied the wires under a 37’ Class A. Plenty of wire. Used the old wire as fish tape. Old system was 17 years old. Compared to that, this one is high tech but reasonably priced. The flat screen is lightweight and it was EZ to cut the dash to fit. Very happy with this backup camera. Good clarity. In reverse, grid lines appear. It’s good. BTW The pics of the monitor on the box is the old monitor which is huge and heavy compared to this flat screen.
# 11
Voyager RV Backup Camera System w/ Night Vision - Rear Mount - 4.3" Screen
Item exceeded my expectations, excellent sales team/communication, I strongly recommend ordering from this store.
What our customers are saying:
"Great service! I really liked the feedback from different individuals as my order was processed. By keeping me in the loop I knew what was happening to my order and it really personalized the buying experience."