For your AL-KO T44 axles, the brake assemblies you need are the Dexter Nev-R-Adjust Electric Trailer Brake Kit - 10" - Left and Right Hand Assemblies - 4.4K # K23-478-479 or the manual adjust # K23-462-463-00 along with spoon adjuster # W80630.
The grease seal you want is AL-KO part 568861 which is the Grease Seal - Double Lip - ID 1.719" / OD 2.565" # RG06-050 for a set of 2 seals. view full answer...
Your Raptor Toy Hauler likely has a landing gear setup similar to the one you were looking at: Lippert Electric Landing Gear Set - Weld On - 37" Lift - 6,000 lbs # LC333964. If so, then the correct replacement motor would be Lippert Components Tuson High Speed 5th Wheel RV Landing Gear Motor # LC141893 which is rated for 5,000lbs, or you could go with Lippert HD 6500-lbTuson 5th Wheel RV Landing Gear Motor # LC196308 which is rated for 6,500lbs. This is the heaviest duty motor we have for... view full answer...
Since you mentioned that you broke a leaf spring and not the axle, in order to determine which replacement leaf springs you'll need for your 2017 Keystone Bullet Premier Ultra Lite Travel Trailer you will need to measure your current springs from the centers of one spring eye to the other. This distance is going to determine which springs will fit as a replacement. Since we know you have a 3500-lb axle, we can narrow it down a bit.
If your old springs measure roughly 23-1/8" long from... view full answer...
The correct replacement circuit and control board for your Lippert Electronic leveling system is the Replacement Control Panel for Lippert Ground Control 3.0 and Travel Trailer RV Leveling System # LC421484. This will be a plug and play solution, so it's easy to install and will not require any type of programming. view full answer...
Thanks for providing all of the information for your axle. This axle is going to use the standard 3,500 lb axle bearing sizing. You can use the Bearing Kit # BK2-100, which will come with bearings, races, seals, cotter pin and tang washer - everything you will need to repack your hub. We can also provide bearing grease # L11380, if you are in need. view full answer...
The correct replacement brake shoes for a 2013 Keystone Montana Mountaineer with Dexter 7,000 lb Nev-R-Adjust Braking Assemblies is going to be the Replacement Shoe and Lining for Nev-R-Adjust 12" x 2" Electric part # K71-675 for the left hand side or part # K71-676 for the right hand side. That said, we also offer the Dexter Nev-R-Adjust Electric Trailer Brake Kit part # 23-464-465 which will save you some work.
If you need new hubs/drums, the Dexter Trailer Hub and Drum Assembly part... view full answer...
I reached out to my contact at Lippert and based on the NV 248685 your 7000lb Lippert axle uses inner bearing # 25580, outer bearing # 14125A, and grease seal # GS-2250DL.
Now this grease seal has a 2.250" I.D. which is the same as the seal you purchased, so I do not have a good answer to why yours is not fitting as that is what your axle was designed to use.
I was unable to find an order through us so I recommend double checking the dimensions of the seal you ordered to make sure it... view full answer...
The best replacement option we have for your discontinued Dometic DOTR12CBIV Over-the-Range Microwave , is the Greystone Standard RV Microwave w/ Trim Kit # 324-000106.
The dimensions of this option without trim kit are 19" wide x 12" tall x 14-1/4" deep. With the trim kit, 23-3/8" wide x 15" tall x 14-1/4" deep.
Please note the linked product review video below. view full answer...
I looked up this Greystone Range Hood G22BRHT-EL-VD and it appears to be a 22" wide vent hood for a ducted system. While we do not have a direct replacement available, we do carry the Ventline Pinnacle Ducted RV Range Hood # VE78SR which is a suitable 22" wide replacement.
We also have them available for ductless systems with part # VE48SR. view full answer...
The Replacement Touchscreen Remote w/ Charger for Lippert Ground Control 3.0 Electric Leveling System part # LC358601 is only for use with the Ground Control 3.0 System. For a remote that works the other electronics the Replacement New-Style Linc Analog Remote part # LC292614 is what you are looking for.
I have linked the pairing process in the attached photo for you to check out. view full answer...
For your 2008 Keystone Montana Big Sky Fifth Wheel I recommend the Lippert Components Venture 5th Wheel RV Landing Gear Motor part # LC142178 which is a direct fit and will work well for you. This motor has a 5,500 RPM rating and is made right here in the U.S.A.
If the legs retract/extend with the manual override but not the switch and you have checked the wiring then chances are the motor is bad and needs replaced. view full answer...
We have a few options for you to choose from:
- Replacement Manual Override Grommet for Solera Powered RV Awnings # LC95ED
- Replacement Crank Access Hole Cover for Solera Manual Crank-Style RV Awnings # LC299993
If the plug you're looking for looks different than either of these please shoot me a photo and let me know what style awning you have so I can make an alternative recommendation. Please note these are designed for Solera awnings so if you have a different brand they may not work. view full answer...
Only one photo came through, but Dometic bought out that portion of Atwood. We have the Replacement Lid for Dometic Refrigerator Vents - Polar White # VM65528 which may fit your Atwood fridge. The overall dimensions are 27 inches by 10-3/4 inches with the holes being 4-3/8 inches on center and 21-5/8 inches on center. I've attached a photo to assist. view full answer...
Hello, I would be glad to help you with the needed tire selection but I need to know what size tires you are replacing, please let me know the tire size and I will work up a list of recommendations for your 2017 Keystone Passport Ultra Lite Grand Touring Travel Trailer.
Please note the linked help article below for "Measuring a Trailer Tire". view full answer...
We do indeed offer a replacement remote for your Jensen # JWM40 RV Stereo. The replacement remote controller is sold in a service pack as part # JEN94FR which also includes the wiring harness. view full answer...
I contacted the manufacturer about what thermostat would be the correct replacement for your Dometic 3316410.012 Thermostat. They informed me that the Replacement Single Zone Thermostat for Dometic RV Air Conditioners # DMC79FR is the correct replacement for your Dometic 3316410.012 Thermostat. view full answer...
You will be able to mount the Solera 12V Power RV Awning Conversion Kit - Universal - 69" Arms # LC434723 on your 2019 Keystone Cougar 26RBS trailer. As far as the specific measurements of the Solera 21' Replacement Awning Fabric - Solid Black # LCV000334448, I would not be able to determine the exact length of fabric you need without measuring the distance between of the center of the left arm to the center of the right arm. For the correct size, I recommend making that measurement. I... view full answer...
From the photos you attached, the bottom half replacement you need for your converter model 7355 is the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers - 55 Amp # PD4655V. This will solve all of the sparking/melting issues you are having with the unit. view full answer...
We carry the Camco RV Refrigerator Vent Cover # CAM42160 (black # CAM42163) which is designed to fit a 26" long x 7-1/2" wide base. If your base dimensions differ then you'll need to replace the base as well with part number # CAM42161 (black # CAM42164).
We also carry an all-in-one replacement with part # DMC97FR, which is designed to fit a 23-3/4" long x 6-3/4" wide cutout.
If you have to replace the base I recommend picking up some butyl tape # AL28FJ for the bottom side of the mounting... view full answer...
The closest replacement we carry to the Furrion Over-the-Range Convection Microwave # FMCM15BL (NLA) is the Furrion Standard RV Microwave # FMSN09BL.
This microwave has overall dimensions of 19-1/16" wide, 13-5/8" tall, and 14-1/16" deep, and has a capacity of 0.9 cu ft.
Additionally, you can use Trim Kit for Furrion Standard Microwave # FMSM09BLTK to provide a sleek finished look. view full answer...
Go To Results