The EcoHitch Hidden Trailer Hitch Receiver - Custom Fit - 2" # 306-X7303 based on capacity is comparable to a class II hitch. It does have the 2 inch receiver for compatible accessories similar to the class III and higher hitches but the max tongue weight for this particular hitch is 300 lbs. It can use those larger accessories you will just be restricted to 300 lbs tongue weight. view full answer...
To keep your pair of bikes spaced out as much as possible so they don't damage each other, getting the Yakima FullBack 3-Bike Rack # Y02633 instead of the 2-bike version is certainly a smart idea.
This bike rack is a fit for your 2019 Mazda CX-5, and it won't damage your vehicle so long as you take the proper precautions. There are specific instructions to mount the rack in "Anchor Mode", which you can see on page 5 and 6 of the linked installation instructions. Yakima also says to be... view full answer...
Unfortunately the Curt wiring harness # C45FV would not activate the tow mode on your 2023 Mazda CX-50. According to Mazda, only their OEM wiring harness will work with the tow mode. You can absolutely still use the # C45FV to work your trailer lights, but the tow mode will not activate. view full answer...
Payload is any weight added to the vehicle, including cargo and passengers inside; it doesn't matter if it is in front or behind the rear axle. Tongue weight, on the other hand, is any weight added behind the rear axle of the vehicle; this includes cargo in the trunk or bed along with the tongue weight of your trailer. Tongue weight counts as payload.
In your case, the cargo carrier and everything on the cargo carrier will count as tongue weight, thus counting as payload as well. I attached... view full answer...
Yes, the Replacement Tensioning Bolt Plug for Thule Traverse Foot Pack # 8526446001 are designed to keep dirt and grime out of the socket used to tighten the feet. view full answer...
I contacted the manufacturer, Lippert, about this and they gave me a spec sheet with all of their available information about the Replacement Gear Motor Assembly for Lippert Electric Slide-Out # LC386322, which you can see.
This motor operates at 15 RPMs with a 15 amp draw, as you can see in the cut out. I have also added a link to a video review of this motor for you to check out. view full answer...
I did some online research for your 1988 Mazda B Series pickup and was unable to find specific information for towing. Typically, on a 2-wheel drive manual transmission vehicle, they can be safely towed if the vehicle transmission is in neutral. On a 4-wheel drive vehicle they can also typically be towed safely if the transmission is in neutral and the transfer case is in neutral as well, but I strongly urge you to consult your owners manual or your Mazda dealership to make certain your... view full answer...
The issue with your 2021 Mazda CX-5 isn't the wiring or ground, it's that you only have a 4-way, which controls the lighting, but does not control electric trailer brakes. Electric trailer brakes won't work without a 7-way and a brake controller, so you'll need a few extra parts:
- Universal Installation Kit for Trailer Brake Controller # ETBC7
- Curt Spectrum Trailer Brake Controller # C51170
- Universal Wiring Adapter # C51515
The 7-way that comes with the # ETBC7, which also gives... view full answer...
The Ultimate Tuf Combo License Plate Frame and Clear Shield part # CR62510 has a black border with clear cover that is not tinted by definition so you won't have issues with law enforcement but does help reduce the intensive of the reflective material used on license plate lights like what you are after. The Tuf Bubble Shields for License Plates are offered in clear part # CR73100 (above), blue part # CR73400, and smoke part # CR73200. That said, we don't offer a Tuf Bubble Shields for... view full answer...
The Curt 2 Bike Platform Rack - 1-1/4" and 2" Hitches # C18085 has a shipping weight of 50lbs and packaging probably weighs 2-3lbs so 46lbs is the correct weight. This hitch has an extra folding feature the others don't which adds more weight and that along with the 10" rise and less plastic used is most likely the difference in weight compared to the others. view full answer...
The EcoHitch Hidden Trailer Hitch Receiver - Custom Fit - Class III - 2" # EH55VR weighs 31 pounds. And its shipping weight is 35 pounds view full answer...
The Rola 59833 does not give a decibel increase when the rack is installed as that will change based on speed and change with the weather conditions.
Most roof rack systems will have a noticeable sound because you are changing the aerodynamics of your vehicle by adding the crossbars. The bulkier the system the more noise, so square bars and bulky towers will be the worst offenders. The Rola rack you asked about has very sleek lines with aero crossbars for a more factory appearance... view full answer...
From what I have seen, there are 2 different configurations for landing gear jacks like # BD182815. First is like the jack you have referenced that has the foot release is perpendicular to the rod through the top center of the jack. The other configuration is like # BD182411, with the release parallel with the top rod.
Jack # BD182411 is a companion to the Bulldog Square Jack # BD182400. The Bulldog Square Jack, # BD182404 and can be used in tandem operations with either of the first two... view full answer...
You can find out if you have LEDs a couple of ways. The easiest is to remove the lens of the lights and if it has a bulb it is incandescent. If it has diodes then it is LED.
Another way is to turn the lights on and then watch as you turn them off. If the light go off abruptly, they are probably LED. If the filament takes a moment to go out then it is probably a bulb.
The third way is to contact your dealer with the VIN and they will be able to tell you what lights are on your Mazda 3. view full answer...
It seems that the person you spoke with is confused. A stabilization strap and an anti-rattle bolt do not serve the same purpose. A stabilization strap helps support the non-trailer load on the hitch, while an anti-rattle bolt helps to eliminate the rattle or wobble of the shank in the trailer hitch.
Per Curt's warranty, the # 18050 stabilization straps need to be used with all non-trailer loads. I spoke with my contact in Curt's technical department who confirmed that the stabilization... view full answer...
I spoke with Rhino-Rack about the Rhino-Rack 2 Bike Rack part # RRRBC045 and they informed me that this bike rack has not been updated since its release so I can confirm we have the most up to date version. The frame cradles which hold the bikes to the upright arms are cushioned and there is even anti-sway devices built-in. view full answer...
No, there is not a risk of parasitic battery drain for the Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector # C56377. view full answer...
Good question. The Stabilizer Jack - 6-1/4" Drop Leg Travel - 18" - 650 lbs - Qty 1 # TJ01RT doesn't come with the Replacement Handle Rod for etrailer and Ram Stabilizer Jacks - 650 lbs # SJ-100-HD which does come included in the kit # TJ01RT-HD.
The pricing does change based on the manufacturer costs and stock at any given time, so it is wise to compare as you have done. view full answer...
The overall weight of the Roadmaster Direct-Connect Base Plate Kit part # RM-524450-5 which is a fit for your 2016 Mazda MX-5 Miata is right at 50 lbs. If you can let me know what all components you are interested in I would be glad to give you the overall weight of each product. view full answer...
Go To Results