Hey Jeff. There is definitely a correlation between weight and capacity. I've listed the weight of all three of the Power Mountain Tallboy Off-Road Bottle Jacks we have below:
Power Mountain Tallboy Off-Road Bottle Jack - 7-15/16" to 26-3/4" Lift - 2 Tons - item # PM44FR - weighs 15.24 lbs
Power Mountain Tallboy Off-Road Bottle Jack - 8-1/2" to 37-3/4" Lift - 6 Tons - item # PM34FR - weighs 27.09 lbs
Power Mountain Tallboy Off-Road Bottle Jack - 11-5/16" to 27-1/16" Lift - 12 Tons -... view full answer...
Hi Donald!
The MouseBlocker PROx Plug In Electronic Rodent Deterrent - 110V AC # MB34FR is rated to protect up to 400 square feet. However, it is mostly intended for direct protection and not necessarily a large area. Think vehicles, trailers, and even some Class A motorhomes (depending on their size). That kind of thing.
What are you thinking about using this for? Other than keeping pesky rodents away, of course. view full answer...
Hey Eric! There has definitely been some confusion around the specs on this scale. I just contacted B&W and can confirm that the B&W Digital Tongue Weight Scale w/ LED Screen # BW34KR has a max capacity of 4,000 lbs. It has been listed on our site for almost a year while we waited for B&W to release it so information has slowly trickled in and changed over time. view full answer...
Hi Carl; the saddle attachment on the Power Mountain Tallboy Off-Road Bottle Jack # PM34FR is 3-1/4" wide at the base of it before the sides flare out. What will you be using the jack for? view full answer...
Hello Dennis. The trim piece for the High Pointe Built-In Convection Microwave measures 24" wide by 17" tall. I made a diagram for you which I have included below. view full answer...
Hi Todd,
To go with trailer leaf springs that are slightly stiffer than the 4,400 lb rating of your axle you can go with 4,500 lb springs or 5,000 lb springs. The right one is going to depend on the length of your current springs though, as you'll need to measure from center eye to center eye of your springs to get the right length.
You'll want to measure with the trailer jacked up and no weight on the springs if you can, and since leaf springs flatten out a bit over time, you can go... view full answer...
No, Thomas it does not have any weight limitations. The etrailer Anti-Rattle Hitch Collar for 2" Hitch Receivers item # e38FV attaches directly to the lip of your vehicle's hitch. Doing so allows it to limit the movement of the ball mount or accessory. It does not affect the ability or capacity of your vehicle to pull a trailer.
What kind of trailer are you wanting to pull and what vehicle are you planning on using? view full answer...
Hey Pat,
The Rhino box definitely is shorter than what most Rver's were hoping for so we get this question all the time. Switching to a MORryde Cushioned pin box designed with a Rhino box bolt pattern unfortunately won't give you extra clearance since they made them with a matching 13.27" length from the king pin to the first set of bolt holes. It will help reduce chucking and road vibration though. If you went with this pin box you'd want part # MR83QR to match your GVWR to the shear... view full answer...
The # CSS-1168R and # CSS-1195F are only confirmed to fit the FWD models but that doesn't mean there aren't Coil SumoSprings for your 2023 Sienna AWD. To find the right size you will need to measure the gap between in the middle of the coil.
Take the measurement with the vehicle as it sits. You do not need to raise it. Ensure that each side of the vehicle is within 1/4" (0.25") measurement of the other. If you only want them in the rear you don't have to measure the front. Once you have... view full answer...
Hey Tom, great question! Both products provide an easy way to measure tongue weight, but they excel in different situations. The BTBRV Trailer Jack Foot Scale # BTBRV014 measures tongue weight at the trailer jack, so you don't need to position a separate scale under the coupler. This can be especially convenient if you're making adjustments while the trailer is already parked or if you'd rather not move your tow vehicle out of the way to place a standalone scale.
If you regularly tow multiple... view full answer...
Hey Mike. The Norcold RV Refrigerator item # NC67VR measures 24" without the doors. With the doors it's 24.9" deep. I have attached a diagram below with quite a few measurements.
The Norcold item # NC67VR draws 6.5 amps.
What kind of fridge are you replacing? view full answer...
Hey Adrian! The higher capacity for the B&W # BW47BR and Curt # C77MJ comes from the construction. The B&W hitch weighs 45 lbs and then the Curt and Trailer Mate # TMT54FR both weigh 32 lbs. The Trailer Mate does sit just a tad higher compared to the others. The distance from the gound to the top inside of the receiver tube is 12". The same measurement is 11-3/4" for the B&W hitch and then 11-1/2" for the Curt.
The Trailer Mate Hitch # TMT54FR is a budget friendly option that is actually... view full answer...
To find the correct replacement equalizer and wet bolt/shackle strap kit for your 2024 Grand Design Imagine XLS 22BHE you'll need to first take a few measurements. For the equalizer you'll want to measure from center to center of the shackle strap bolt holes and from the center of the hanger bolt hole down to the center of the shackle strap holes. For the wet bolts/shackle straps you'll need to measure from center to center of the bolt holes.
When replacing suspension components it's... view full answer...
Hello Rocky, thanks for reaching out. If your new leaf springs do not have as much of an arch as the old springs they are definitely not going to help your situation if your tires are already rubbing on the fenders. What we would usually do here is look at the unloaded dimensions of the current spring and try to find something that matches.
Just for an example, take a look at the dimensions of the 4-Leaf Double-Eye Spring # DX23CR below. It measures 25-1/4" across and the "arch" is 3"... view full answer...
Hey Carole, thanks for reaching out!
The Swagman Swivel Hitch Extender # S86SR has arms that are about 29-1/2" long. Swagman actually has a dimensional photo that gives more dimensions that you'll ever want that I'm attaching for you to check out.
There are some other swing away arms, but they are only rated for 250 lbs so this 300 lb rating is the most you're going to get.
What do you plan on using this for? view full answer...
Hey Martin, we can definitely help with that. Your exact tire size is only available in an off-road style but the next closest size is the ST225/75R15 which we offer with the # TR225LRE. This would be just a tiny bit smaller than what you have now but it would work great and be A LOT quieter! Did you ever use your current tires in an off-road capacity? view full answer...
Hey Shane! The closest axle we have to those dimensions is the Trailer Axle w/ Electric Brakes item # e73SR. It has a 86-1/2" hub face and a spring-center-to-spring-center length of 71-1/2". You may be able to get away with the hub face being slightly longer depending on your fenders but you'll need to use the Spring Seat item # TRSS300 to replace the ones that come with the axle. view full answer...
Hi Stephen,
If your weight distribution hitch is overrated for the tongue weight of the trailer then it will over-distribute the weight and start lifting both the trailer tongue and rear of the tow vehicle up. You'll notice handling issues while towing and the stiffer spring bars will be harder to get mounted to the frame brackets.
To size your weight distribution hitch you'll want to first fully load your trailer like you would if you were going camping and then measure the tongue... view full answer...
Hey Reuben, thanks for reaching out!
The Weigh Safe Safe Load Gooseneck Ball # WS27MR sits 10" tall while the B&W Ball and Safety Chain Kit # BWGNXA2061 sits 7-1/4" tall. The height measurement is take from the ball bearings to the top of the hitch ball - so you'll get an extra 2-3/4" of height out of the Weigh Safe.
Check out the attached photos to see the difference.
Are you trying to determine what you need for your gooseneck trailer to sit level? view full answer...
Hey Rob! Both the 25-1/4" long item # DX95CR and item # e44SR springs will work if you're replacing a 25-1/4" long leaf spring. They're close enough in capacity so long as you're not using too light of a spring with the 4,400 lbs item # DX95CR.
How did you measure your leaf springs to come up with needing a 25-1/4" long one? view full answer...
Go To Results