Robert, for your Draw-Tite # 75119 you're going to need to order the Replacement Hardware Kit # RHK. From here you'd need to put 75119 in the "Hitch Item Number" box and you'll be all set. This kit will include all of the hardware needed for install. view full answer...
Jayco offered the 1999 Eagle 10-UD Pop-Up camper trailer with and without brakes, so I presume you have the version without any brakes. Typically pop-up campers are equipped with electric drum brakes, rather than hydraulic disc brakes such as the Titan kit you reviewed, part # T4843300.
A first step is to review the attached article concerning adding electric drum brakes to a trailer. This covers all of the basics and required components.
It is necessary that your trailer axle has brake... view full answer...
The Curt hitch # 13389 is the correct fitting hitch for your 2007 Dodge Caravan with stow n go seating. The other two hitches fit different vehicle variations.
I attached an install video for this hitch on a 2007 Town and Country similar to yours. view full answer...
For your 14 to 16 foot pop-up camper, I highly recommend the Adco SFS AquaShed RV Cover for Pop-Up Camper # 290-12294.
A lot of covers can be tricky, especially if they don't fit correctly, but the Adco will hold up wonderfully to the bad weather and wind you see. It is a much better fit than other covers because it combines cinch ropes and weighted straps to secure the cover to your camper. The Adco also has corners which are elastic so they stretch a bit but are reinforced to resist... view full answer...
Thanks for your question!
We do have a general listing for replacement hitch hardware instead of having individual listings for each one. Part # RHK is that listing. There will be a spot where you can put the part number for the hitch you are needing hardware for.
You will get all bolts, washers, nuts, and spacers that the original kit would have come with. It wont include any sort of black powder coated brackets that are included with some hitches.
In regard to your other question.... view full answer...
The Curt Trailer Hitch # C12289 will in fact, fit your 2005 Dodge Caravan SE. The hitch will not interfere with any of the vans VMI modifications as it does not get close enough to the rear axle. Additionally, when the hitch it fully installed it is approximately 12 1/4 inches from the top of the receiver tube opening, to the ground giving you plenty of clearance. To fully ensure that our product will fit your vehicle, it would be a good idea and check the instructions and get underneath... view full answer...
Yes, Greg that is correct. The Custom Fit Gas Strut item # ATL64RR, that fits your 2004 Dodge Caravan is sold individually. You will need to purchase two. view full answer...
Hello Matthew; the # 75908 fits the 2016-2020 Kia Sorento and 2019-2020 Hyundai Santa Fe. It will not fit your 1998 Dodge Grand Caravan. What you can use instead is the # 75119. This is specifically designed to fit your van. view full answer...
Hey Justin, so the Timbren kit part # TDVR05096 is a fit for your 2007 Dodge Caravan but it really depends on what the modifications that were made to it were. If the suspension is essentially stock then yes this would work but best option would be to compare the install instructions that are attached to your setup to see if there's anything that would interfere. view full answer...
Hey James! I don't have anyway of knowing whether or not a Starcraft pop up trailer from 1998 has brakes. There's over a dozen different models and there's no database available that gives me the information on any of them. If the trailer has a breakaway kit and a 7-way connector I would say it does have brakes.
The Prodigy P3 Brake Controller item # 90195, you were looking at, would be a great option for your 2003 Dodge Caravan. It is a proportional brake controller that slows or stops... view full answer...
The converter has most likely shorted out and needs to be replaced. This will typically occur when one of the lighting circuits on the trailer shorts out, but you can certainly begin by examining that power feed to the converter box from the battery.
If that power feed checks out okay, you'd want to replace the existing converter with part # C56331. On the trailer, trace each of the lighting circuits from the trailer connector back to the lamps. Look for loose connections, broken or pinched... view full answer...
If you are asking me if there is a Curt wiring harness for your 2007 Dodge Caravan there is one. It is the Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector item # C55537. This custom-fit T-connector plugs into your vehicle's wiring harness, which is located behind the tail lights.
I recommend the Tekonsha T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector item # 118300 you were looking at over the Curt. Tekonsha makes a far superior product and their... view full answer...
Brake controllers are not vehicle-specific so the Tekonsha Prodigy P3 # 90195 is perfectly suitable for use in your 2005 Dodge Caravan. You will also need the # ETBC7 brake controller installation kit, which includes the 7-way socket, connectors, wiring, circuit breakers - everything you will need. I have linked both a video and helpful article concerning installing this kit.
If your Dodge Caravan does not already have a working 4-pole flat trailer harness you will also need to install... view full answer...
The trailer hitch you have is the Valley Class III Trailer Hitch, part # V82180. This hitch was designed to fit the Dodge Caravan, Grand Caravan and the Chrysler Town and Country from 1996 to 2007. From years 2004 to 2007, it will only fit models without the Stow & Go Seats. It will also fit the Plymouth Voyager and Grand Voyager from 1996 to 1999 and the Chrysler Voyager from 2001 to 2003. view full answer...
We offer a replacement hardware kit for the Karrite Explorers as part # SR05587. This includes a new pair of locks, new bolts, and replacement for almost every moving part of a Karrite Explorer.
The up to the minute pricing is available on each product page.
You'll notice that all of these parts are Sport Rack branded. Sport Rack and Karrite are both owned by Thule and all three brands use interchangeable parts. view full answer...
The 2006 Dodge Caravan/Grand Caravan has a towing capacity dependent on the tow package and engine size. The 3.3L V6 can tow 2,000 lbs without or 3,600 lbs with the towing package. The 3.8L v6 can tow 2,000 lbs without or 3,800 lbs with the towing package. Your SXT model has a towing capacity of 3,700 lbs.
If you have stow-n-go seats, I recommend the Curt Class III # 13389 for your trailer hitch receiver. If you do not, then I recommend # C13362.
For your trailer wiring, I recommend... view full answer...
The # 36257 Hitch that you referenced is no longer an active part so I called my contact at the manufacturer and found that it fits the 1996 - 2004 Dodge Caravan and Grand Caravan All, including 4WD. Stow-N-Go was not available until 2005.
There are 6 models of hitches for the 2005 Dodge Grand Caravan with Stow-N-Go seating (see link). I would recommend the Draw-Tite Class III Trailer Hitch, item # 75305, which has a 2 inch receiver that will allow for the widest range of accessories on... view full answer...
I went out to the warehouse and took the measurements on the Draw-Tite Class II, part # 36296. The mounting holes are 37-1/4 inches center on center for both set of holes. From the top of the brackets where it mounts to the frame to the top of the receiver tube is 3-3/8 inches. I'm not sure which direction of the hitch you're calling the rearmost, so I took two measurements. From the edge of the brackets towards the front of the vehicle to the closest point of the receiver tube is 10-5/8... view full answer...
There are several components you will need to flat tow your 2005 Dodge Caravan. But before we get into that you should check the owners manual of your vehicle to determine if there are any restrictions on your vehicle being flat-towed. My research indicates that some modification would need to be made to the driveline in order to tow the vehicle without damaging it.
Now for the parts needed to flat tow your vehicle. You will need the Roadmaster XL Base Plate Kit, part # 275-1, for your... view full answer...
All of the kits you mentioned are spring kits for brake assemblies. Since you said you have 10 inch assemblies the part # AKBRKR-SP is most likely what you need as it fits this size and most common brake assembly brands. view full answer...
Go To Results