Equalizers need a strong pivot point to keep the suspension geometry right. This 1" diameter, Grade 5 suspension bolt gives the equalizer a solid mount to the center hanger so it can move the way it’s supposed to. It keeps the setup tight and steady so the axles share the load evenly and the trailer tracks straight.
Whether the suspension runs two or three axles, this 5" long bolt is built to handle the job. It’s made for equalizers in tandem- or triple-axle systems, giving each axle a strong, centered connection point that keeps the ride smooth and balanced.
A loose fastener can throw off the whole suspension. This bolt works with locknut 6-112 (sold separately) to keep the equalizer firmly clamped in the hanger. Once tightened, it holds its torque and resists loosening, even through long miles and rough roads.
With 8 threads per inch and a total length of 5", this suspension bolt is sized to match common center hanger and equalizer mounts. It threads smoothly and installs cleanly so your suspension rebuild or upgrade goes together without fighting the hardware.
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Hello, everybody, this is Jeff at etrailer.com. Today, we're gonna take a look at this five-inch long Equalizer Suspension Bolt. Now this suspension bolt is used to attach the equalizer to your center hanger on your trailer. This has a nice zinc finish to it and it does require a lock nut for installation. That lock nut is not included. We do sell that separately on our website.
It's part number 6-112. I happened to pull it just to show you that we do also sell the bolt and the lock that together also that would be part number 7-182-6-112. And again, that's sold separately on our website. This part is just for the bolt itself. Now the diameter on this bolt is right here.
It's going to be one inch. The threads per inch are eight threads per inch. The hex head size right here is one and a half inches. And the length we mentioned is five inches. And that's measured from under the hex head to the very end of the bolt.
So there's your five inch measurement, and this is a grade five bolt. If you look closely, you'll see on the head, the way you can tell that is it has three lines on it and that lets you know that it is a grade five configuration. But that should do it for the review on this five-inch long Equalizer Suspension Bolt..
Ratings & Reviews
Fair pricing
fast shipping thanks really needed it..
Good Thank
Junk, soft, low grade material. I would not have bought this if I knew it was that soft.
I am replacing the. Hydraulic ram on my 1986 Case 570 LXT tractor that has grease certs, so I needed a way to lubricate the new ram. Your bolts appear to be what I needed and at a reasonable price I will send a picture when done. Not quite a shackle operation.
New bolt fit perfectly on my Take3 48ft Car Hauler. I had to cut the old bolt off due to bolt friction welding itself to the sleeve inside the bushing in the equalizer bar. Bought all new components from E-Trailer and got my trailer back up and running. I used the 6-112 Locknut on this bolt, it it all fit perfectly.
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.