This 2-1/2" round red side marker packs four high-end LEDs that put out a clean, bright P2-rated glow while only drawing 0.06 amps at 12V DC. It runs anywhere from 9 to 14 volts, so it stays reliable across different setups without overloading your system. You get the visibility you need with very little power use, and there’s no worrying about replacing bulbs down the road.
Built for harsh conditions, this light is fully sealed to an IP68 standard, meaning it’s both dustproof and waterproof—even submersible. TecNiq’s TecSeal urethane potting protects the circuit board from moisture and vibration, so the electronics stay safe whether it’s on the road or around water. It’s made to last through years of weather and heavy use.
At just 3/4" deep and 2-1/2" wide, the low-profile housing fits neatly into a grommet mount. It installs in a standard hole for a flush finish that looks clean and stays out of harm’s way. The PL2 non-polarized connector (sold separately) makes hookup straightforward—no need to worry about wire orientation or complicated wiring steps.
This light comes with TecNiq’s lifetime warranty, showing how confident they are in its build quality. With rugged materials, sealed electronics, and ultra-efficient LEDs, it’s designed to keep working long after cheaper lights have failed. Once installed, it just keeps doing its job—bright, dependable, and maintenance-free.
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Hi, everyone, Steven here with etrailer.com. Today, we're looking at our TecNiq Side Marker with Reflector. It's a two-and-a-half-inch round four-LED light. So folks, again, powered by four LEDs, they are behind the lens, you can't really see 'em, and you have two plugins here in the back for your connector that's sold separately. This urethane true seal potting material guarantees that circuit board's gonna be protected behind that lens, and it uses a non-polarized standard connector, again, sold separately. Again, two and a half inches in diameter, about three quarter inches thick or tall.
It is a P2 rated red light. Now, you will need a grommet, sold separately, to mount this into a standard hole. Let's go ahead and get it powered up so we can take a look at this, and bear with me here while I get everything connected and turned on. Okay, so as you can see, a nice vibrant red color. I'll go ahead and switch off the overhead lights so we can get a better view.
So again, nice deep red, this will be great for being visible on the road while you're traveling up and down the roads, and you can see those four LEDs, one center, three kind of in the triangle shape around it. So again, folks, a great option if you're looking for a replacement or just adding a nice side marker with built-in reflector. This is a red TecNiq. I'm Steven, thanks for watching, and, as always, if you have any questions, reach out to us. We're here to help assist you in any way we can.
Have a good one.
Customer Satisfaction Score:
98% were satisfied with this product
2% of customers were not satisfied
Ratings & Reviews
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.